White Truck White Truck 1981

Model White Truck made in 1981 by White Truck got 2 recalls. There was one recall concerning steering .

Model 1981

Recalls


CampaignManufacturerManufacturing dateType# of units affectedDate Owner notified MfgRecall Initiated byManufacturers of recalled vehicles/productsReport Recieved DateRecord Creation DateRegulation Part NumberFMVSS Number
STEERING - LINKAGES - LINK - DRAG - CONNECTION
82V008000WHITE MOTOR CORPORATIONfrom 12/01/1980 to 10/01/1981V (Vehicle)5304/23/1982MFRVOLVO TRUCKS NORTH AMERICA01/25/198202/01/1982
Defect SummaryThe front axle steering arms installed on the suspect vehicles are of a slightly different configuration than those designed for the application. use of the wrong steering arm presents the potential for improper steering arm to drag link adjustment, which may result in steering lock-up during a full right turn.
Consequence Summary
Corrective SummaryDealer will inspect the suspect vehicles and replace defective steering arms at no cost to owner.
NotesVehicle description: trucks, heavy.system: steering; steering arm.consequences of defect: steering lock-up during operation can result in loss ofvehicle control and an accident.
STEERING - WHEEL AND HANDLE BAR
81V122000WHITE MOTOR CORPORATIONfrom 07/01/1975 to 06/01/1981V (Vehicle)3170302/01/1982MFRVOLVO TRUCKS NORTH AMERICA10/14/198110/27/1981
Defect SummarySteering shaft binder bolts on certain vehicles are either loose or over-tightened. either condition can lead to a separation of the steering shaft from the steering column, even if the factory installed bolt has been properly retightened.
Consequence Summary
Corrective SummaryUnique bolts have been designed for this campaign and will be installed along with new nuts. this will be done at no charge to owner.
NotesVehicle description: trucks.system: steering; steering shaft binder bolts.consequences of defect: shaft separation could result in loss of vehiclecontrol and an accident.note: as a precaution, immediately check the binder bolts on the steering shaftfor looseness. if they are loose, tighten them to 60 ft-lbs torque. tighteningbolts does not permanently remedy the defect. new bolts and nuts must beinstalled.