Recalls


CampaignManufacturerManufacturing dateType# of units affectedDate Owner notified MfgRecall Initiated byManufacturers of recalled vehicles/productsReport Recieved DateRecord Creation DateRegulation Part NumberFMVSS Number
SEATS
93V187000GENERAL MOTORS CORP.from 08/01/1984 to 01/01/1991V (Vehicle)60420701/20/1994ODIGENERAL MOTORS CORP.11/16/199311/29/1993
Defect SummaryThe recliner mechanism and the seat frame may have foam and/or vinyl between them, creating a soft joint. this soft joint results in lower than specified bolt torque which leads to joint looseness, causing bolt fatigue and eventual bolt failure.
Consequence SummaryIf bolt failure occurs to the driver's seat, it wouldallow the seat back to suddenly recline, and could result in loss of vehiclecontrol and a vehicle crash without prior warning.
Corrective SummaryDealers will remove the foam and/or vinyl from between the recliner mechanism and the seat frame soft joint and replace the recliner bolts.
NotesSystem: interior systems; seat tracks, anchors, and seats.vehicle description: vans and utility vehicles equipped with bucket seats withknob type recliner mechanisms.note: if your vehicle is presented to an authorized dealer on an agreed uponservice date and the remedy is not provided within a reasonable time and freeof charge or the remedy does not correct the defect or noncompliance, pleasecontact the gmc service center at 1-313-456-4547 or the chevrolet service centerat 1-800-222-1020. also, please contact the national highway traffic safetyadministration's auto safety hotline at 1-800-424-9393.

Investigations


NHTSA IDManufacturerDate openDate closeSubjectRecall campaign
SEATS
EA92022GENERAL MOTORS CORP.06/24/199211/19/1993SEAT BACK BOLT BREAKAGE93V187000
 There is no summary currently available

Consumer Complaints


Fail datemilesoccurencesPurchase date
SEATS
07/18/1999
 While driving at 35 mph, seat broke from the bottom and fell back, causing vehicle to run off the road. *ak
06/21/19960
 Driver's side seat track/anchor failed; also, seat belt faie=led to restrain driver, was ejected from vehicle. *ak
SEATS - FRONT ASSEMBLY - POWER ADJUST
04/19/200450000111/01/1990
 The driver's seat underside frame track runners that attach to the automatic seat adjustment motorized system has failed to maintain its proper function. the right side runner was made from an alluminum alloy and the left side runner was made from a steel alloy. the steel alloy has held up and maintained its position throughout the years. however, the alluminum alloy runner on the left underside of the driver's seat has broken and lost all functionality. this causes the driver's seat to severly lean towards the right and back. along with the current saftey recalls about the interal frame of the seat design. other 1990 chevrolet astro vans that have the current problem could have a very serious injury, if not a fatality upon even a moderately lowspeed collision from any direction. in 1993, we brought the van back to a dealer to have the seat repaired, however, the same problem has accured once again. obviously, the manufacturers part design has a clear defect.*ak
 When traveling the driver's side seatback collapsed to the reclining position, causing the consumer to lose control of vehicle. consumer has yet to contact the dealer. also, right support of the power adjusting seat cracked into two pieces. *ak
10/04/1994
 Electronic power seat releases from track due to cracks around the bolts retaining the top edge of seat mechanism. tt
SEATS - FRONT ASSEMBLY - RECLINER
111/01/2001
 Vehicle was modified into a conversion van. driver's seat busted and fell backwards. *ak the part which supports the back of the seat failed. *jg
 When traveling the driver's side seatback collapsed to the reclining position, causing the consumer to lose control of vehicle. consumer has yet to contact the dealer. also, right support of the power adjusting seat cracked into two pieces. *ak
03/01/19951
 Drivers seat back collapsed backward instantly to the floor while driving due to hinge breakage. tt