Bulletins
| Bulletin | Bulletin date | Replacement Bulletin | Item no. | Summary | Added |
|---|---|---|---|---|---|
| VISIBILITY - REARVIEW MIRRORS/DEVICES - EXTERIOR | |||||
| 000851001 | 09/01/2000 | 6092333 | Some customers may comment that the black plastic housing around the outside rear view mirror turns chalky or is dull in color. *tt | 12/05/2000 | |
Consumer Complaints
| Fail date | miles | occurences | Purchase date |
|---|---|---|---|
| VISIBILITY - DEFROSTER/DEFOGGER SYSTEM | |||
| 1 | 12/01/1997 | ||
| Hvac blower motor quiet for the first few weeks, but eventually makes a loud roar, replace motor 5 times. loud hum eminating from fuel pump before starting engine and while driving, replace fuel pump | |||
| VISIBILITY - GLASS, SIDE/REAR | |||
| 09/24/2003 | |||
| Lower rear window channel in drivers door rusted and caused channel bracket to separate and window to come out of channel | |||
| VISIBILITY - REARVIEW MIRRORS/DEVICES - INTERIOR | |||
| 08/01/1998 | |||
| The center/side rear view mirrors have blind spots. there is an area on the left side in which a vehicle approaching from the rear left side is not visible from either the center or left rear view mirrors. this blind spot is located approximately such that a vehicle located with its right bumper six feet behind and six feet to the left of my left rear bumper is not visible. the only way i can see a vehicle in such a position is to take my eyes off the road and turn my head to the left. otherwise, anytime i make a left lane change to my left, there is a risk of a collision in which i never saw the other vehicle. there is a similar situation with the center/right rear view mirrors. i have determined these facts by moving my car in a parking lot past stationary vehicles and observing the image of the stationary vehicle in my rear view mirrors. i assume that the mirrors on the monte carlo are typical and that this problem exists on all automobiles. the mirrors on my car are in good working order so that this is problem is not due to a malfunction. this problem is due to design defect. the problem can be eliminated by careful layout of the mirrors and employing simple geometrical optics. | |||
| VISIBILITY - SUN ROOF ASSEMBLY | |||
| 10/15/1997 | 1 | ||
| Sunroof actuator replaced due to sunroof rattling, sticking and binding. | |||
| VISIBILITY - WINDSHIELD | |||
| 1 | 12/10/1997 | ||
| Windshield design allows for reflection of vents and dash equipment to distract from view. | |||