Bulletins


BulletinBulletin dateReplacement BulletinItem no.SummaryAdded
ENGINE AND ENGINE COOLING
090020401/27/2004090050310005587Short duration cold engine start-up ticking like sound. this bulletin applies to vehicles built prior to march 31, 2003. *mn03/04/2004
180420311/28/200310005289Flash-rough idle. *ph02/18/2004
ENGINE AND ENGINE COOLING - ENGINE
090050311/21/200310005297Short duration cold engine start-up ticking like sound. *tt02/19/2004
090020303/14/200310002279Engine stumble and/or misfire - malfunction indicator lamp illumination. *tt08/20/2003
ENGINE AND ENGINE COOLING - ENGINE - GASOLINE
180210208/26/2002635685On some vehicles, there is malfunction indicator lamp illumination with possible rough running engine and any or all of diagnostic trouble codes p2302, p2305, p2308, p2311, p2314 p2317, ignition coil secondary circuit. *tt10/30/2002
ENGINE AND ENGINE COOLING - EXHAUST SYSTEM - EMISSION CONTROL
C2310/01/200310004000Vehicle emission control information (veci) label replacement - emissions recall no. c23. *tt11/12/2003

Consumer Complaints


Fail datemilesoccurencesPurchase date
ENGINE AND ENGINE COOLING
10/15/2009580004
 Events leading to failure: ordinary driving, including high speed acceleration, low speed acceleration, low speed deceleration, stopped, idling in gear. 5 occurrences in 2000 miles. engine fails completely, followed by immediate restart capability. normal operation for many more miles. car's computer fault code report is consistent with description contained in chrysler recall below. chrysler recall (notification code j18) appeared to address the issue, but was rescinded. was told by dealer service dept. that chrysler is working on the problem, no solution yet (2 weeks after receipt of the recall notice.) dealer recommended the car not be driven. present situation: must either drive an unsafe car or be without transportation. date entered for this report was first occurence. 4 additional events continued through 2009. tw*
06/30/2008601
 My 2003 concorde shut off on me while driving to work on 695 expressway. the engine light came on and i stared to lose power. on 06/30/08 quickly i put my car into neutral and it started back up and continue to work but would not go pass 60 mph. lucky for me there was no heavy traffic or i could have been seriously hurt. there was no sign that the car was going to lose power as soon as the light pop on the car started to lose power. i took the car to a dealership for service and at that time they told me that it was a shorted upstream 02 sensor . i parked the car and did not drive the car until 09/27/08 to the dealership the car was repaired. on 09/29/08 after driving the car for 12 miles the light then pop back on again and the same thing happen it shut off while i was driving. i took the car back to the dealership at this time they told me there was a code that came during the test stated that the cat converter internal was defective and the down stream 02 sensor. i had that replaced. on 10/02/08 after that repair i drove another 24 miles this time and as usual the light pop back on again but this time the car sound as if it was in neutral or different shift and would not pick up speed with a roaring loud noise. i then pull over to the shoulder and turn the car off and then back on again and it continue to drive normal. engine light constantly stayed on. i returned the car back to the dealership for repair at this time they said a different code appear and said the p0420,po430 and they order a ed cat converter and now the left upstream 02 sensor. which they had already replaced the right converter and both sensors now they are working on the left. car was repaired on 10/06/08 after that repair i drove the car to work and on the way home the engine light pop back on for the third time, took the car back to the dealership and now the code say po600 and the pcm and solenoid was programmed and replaced. now i have to get up at 6am to take the car back. *tr
04/01/20032100603/29/2003
 The air bag light would intermittently illuminate while driving at various speeds of 0-30 mph. the vehicle has been to the dealer and several sensors were replaced. the problem keeps recurring. *jb the consumer requested her money back along with a new vehicle. the transmission shifted erratic at times, there was belt noise at the idle, then engine made a ticking noise through out the day and the dealer was unable to duplicate the problem. *sc the camshaft position sensor was replaced. the rear light bulb was replaced. *jb
ENGINE AND ENGINE COOLING - ENGINE
09/27/201074523
 2003 chrysler concorde engine 2.7 with 74000 miles on the odometer. the engine coolant got mixed with the oil, not even the 100k miles range and now i end up with a $9,000 paperweihgt! its not fair that the poor desing and the misleading information on the owners manual (the owners manual says that you can go 7,500 miles before your next oil change) has such a costly result, $5,000 for the engine replace, and chrysler is not doing anything about the problem, they're just blaming the consumer saying we didn't take care of our cars! my car has had the oil changed at 3000 miles every time, thats 4500 miles more often than the recomended safe distance mentioned on the owners manual! c'mon people this is wrong and you know it place a recall for this engine and keep the reputation you guys work for too long to aquire! love chryslers but this is a nightmare!
10/15/2009580004
 Events leading to failure: ordinary driving, including high speed acceleration, low speed acceleration, low speed deceleration, stopped, idling in gear. 5 occurrences in 2000 miles. engine fails completely, followed by immediate restart capability. normal operation for many more miles. car's computer fault code report is consistent with description contained in chrysler recall below. chrysler recall (notification code j18) appeared to address the issue, but was rescinded. was told by dealer service dept. that chrysler is working on the problem, no solution yet (2 weeks after receipt of the recall notice.) dealer recommended the car not be driven. present situation: must either drive an unsafe car or be without transportation. date entered for this report was first occurence. 4 additional events continued through 2009. tw*
09/01/200568034
 Tl*the contact owns a 2003 chrysler concorde which was purchased in 2005. the camshaft sensor continued to fail on the vehicle. there was a manufacturer's recall issued by chrysler to replace the cam shaft sensor and repairs were done; however, the failure recurred. chrysler recall number 18j18182 recall j18 camshaft sensor pcm is related to the failure. the vehicles rpms would not exceed 2500 rpms and began stalling. she also stated that when the engine is turned off it would not restart for approximately one hour. the failure occurred every 12 months. a diagnostic test was performed by an independent mechanic which verified that the camshaft sensor was faulty. no repairs have been made to date to correct the failure. the current and failure mileages were under 68,034.
01/28/2009810001
 Concorde was in perfect condition. oil pressure failure (no light, no warning) caused main bearing to break. only 81,000 miles on car. *tr
07/02/2008721831
 2003 chrysler concord 2.7l engine failed with only 72,000 miles. *tr
12/02/20061200030
 Tl*the contact owns a 2003 chrysler concorde. while driving 55 mph, the vehicle completely shut off. after several attempts to restart the vehicle, it operated properly. the vehicle was taken to a dealer on multiple occasions and stated that the clock spring had failed. this failure prevents the air bags from operating. the vehicle has not been repaired. the current mileage is 65,816 and failure mileage was 12,000.