Bulletins


BulletinBulletin dateReplacement BulletinItem no.SummaryAdded
VISIBILITY - DEFROSTER/DEFOGGER SYSTEM
01013900701/01/2002628856A condition may exist where the customer cannot control the hvac system modes and / or the temperature. *tt03/21/2002
01013900701/01/2002628858Subject regarding loss of hvac system mode and/or temperature control. *tt03/21/2002
16100110/16/2001628006Some 2001 and 2002 3500 series vehicles may exhibit a hvac that operates erratically by loss of temperature, mode or blower speed control, or the blower run at key off. *tt03/01/2002
08010101/08/2001618163Some customer may comment that the windows do not defrost on a timely basis. *tt04/06/2001
VISIBILITY - GLASS, SIDE/REAR
1022200210/22/200210009500Rear quarter glass service replacement kits may have deformed sealing striped when initially removed from their packaging causing dealers to reorder. *tt10/01/2004
VISIBILITY - POWER WINDOW DEVICES AND CONTROLS
0129200401/29/200410013030Bulletin 04-08-64-003, front door power window motor assemblies - warranty repair information. *tt04/06/2005
04086400302/01/2004040864003A10011144Power window motor now available separately from the power window regulatory assembly. *tt updated *eh01/03/2005
12120012/12/2000617781Subject regarding customer complaint of an inoperative rear power window condition. *tt03/27/2001
VISIBILITY - REARVIEW MIRRORS/DEVICES - EXTERIOR
05086400703/01/200510015034Outside rearview mirror housings come loose from base. *tt05/16/2005
VISIBILITY - REARVIEW MIRRORS/DEVICES - INTERIOR
342210017188Inaccurate outside temperature reading on inside rearview mirror. *tt10/27/2005
VISIBILITY - WINDSHIELD
04084800306/01/200410012532Windrush around windshield. *tt03/07/2005
0169801/01/200410006391Windshield reveal molding flutering. service vme. sit bulletin 1450940. *tt04/30/2004
VISIBILITY - WINDSHIELD WIPER/WASHER - MOTOR
07050105/07/2001619775Customer may complain that the wiper motor is inoperative or that the wiper motor fuse blows repeatedly. *tt06/29/2001

Consumer Complaints


Fail datemilesoccurencesPurchase date
VISIBILITY - GLASS, SIDE/REAR
07/22/2002107/05/2001
 After closing driver's side door rear glass shattered for unknown reason. dealer and manufacturer have been notified.*ak
VISIBILITY - POWER WINDOW DEVICES AND CONTROLS
05/17/20051
 Passenger window would not go up when button to raise it was pushed. window would go up and down when mover by grabbing the glass. took it to dealer who took apart the door then said the regulator was broken. a wire cable in the mechanism was broken, but the wire by itself was not available. not covered by warraty, as this was a wear item. mileage on truck 24000 cost $717.00
05/05/200596650111/23/2000
 Passenger-side window stopped working and made grinding noise when button pushed to roll down. disassembled passenger door to investigate. found electric window motor cable broken with obvious signs of corrosion (rust) at point of failure. also noted substantial corrosion on screws holding motor assembly in place.
VISIBILITY - REARVIEW MIRRORS/DEVICES
11/01/2001410/31/2001
 Driver's side mirror vibrates at idle while passenger side does not. condition worsens at highway speeds or on bumpy roads, with no noticeable difference in the passenger side mirror. also, defect appears to be the break away joint not being tight enough to hold the mirror stable.*ak the opposing traffic is a distraction because the red tail lights appear to be flashing, often mistaking them for emergency vehicles. *jg
11/20/2001411/01/2001
 Drivers side mirror vibrates at idle while passenger side does not. this condition worsens at highway speed or on bumpy roads, with no noticable difference in the passenger side mirror. the safety issue is that on 2 lane roads all of the taillights of the opposing traffic are flashing to the point of distraction. also, i due to this effect of taillights being red and flashing in the mirror already, whether a driver would notice an emergency vehicle approaching from behind due to there already being flashing red lights in the mirror. the defect appears to be the breakaway joint not being tight enough to hold the mirror in a stable position as when i hold the joint the virbation lessens, and when i hold the glass against the housing the vibration persists.*ak