Gmc Sierra 3500 2000
Model Sierra 3500 made in 2000 by Gmc got 4 consumer complains as well as 1 service bulletin. Consumer complaints with reference, among others things, to fuel system, gasoline and service brakes, hydraulic. Technical service bulletines regarding engine and engine cooling.
Model 2000
Bulletins
| Bulletin | Bulletin date | Replacement Bulletin | Item no. | Summary | Added |
|---|---|---|---|---|---|
| ENGINE AND ENGINE COOLING - ENGINE | |||||
| PIP-4695 | 09/01/2009 | 10032435 | Gm: loss of power hesitates on acceleration. 4.3, 4.8, 5.3, 5.7 and 6.0 engines coupled with the 4l60e or 4l65e may experience a condition of hesitates, misses or loss of power under acceleration. the vehicle may operate as if it is in r | 03/24/2010 | |
Consumer Complaints
| Fail date | miles | occurences | Purchase date |
|---|---|---|---|
| FUEL SYSTEM, GASOLINE | |||
| 11/24/2010 | 41000 | ||
| Tl. the contact owns a 2000 gmc sierra. the contact stated while driving 35 mph the fuel gauge has malfunctioned while driving. the contact stated it's very difficult to determine how much fuel is in the vehicle. the contact has not taken the vehicle to a dealer or a local mechanic for a diagnostic test. the contact notice a new paper article regarding the fuel gauge and stated the a recall should be issued. the failure mileage was 41,000 | |||
| SERVICE BRAKES, HYDRAULIC - ANTILOCK | |||
| 07/01/2006 | 127000 | 8 | 05/12/2006 |
| Tried to stop on dry pavement, but due to abs malfunction, the truck wasn't able to stop. we have had many incidents where there could have been property damage and possible death due to braking system. the abs would calculate wheel lock up even when the truck did not have lock up and engage system not allowing truck to stop. mailman pulled out in front of truck couldn't slow down, but did avoid accident. ran a stop sign once. almost ran into the side of a building. there are a number of incident's, i know of three or more vehicles with same problems, all are made by gm. wheel bearings and speed sensors must be replaced and possibly axles because there is a ring gear that emits signal to wheel speed sensor, ring gear is on axle or wheel bearing. wheel bearing cost 265.00 a side on my family's 2000 gmc sierra 3500 4x4 crew cab long box dually. an easy zero cost to fix this is to pull out the 30 amp to 60 amp fuse in power distribution center under the hood. this disables the abs and does not allow it to operate. abs light on dash comes on to notify this. this may shock you, but i don't like abs anyway and if your a safe driver you don't need abs in the first place because if something happens in front of you that isn't controllable, your going to hit them or if your smart, you will go for the ditch. anyways with the fuse pulled you will have the same brakes that you had before, only that the abs will not be able to help you stop in a case where there is wheel lock up, not that it was helping anyway (this is why i am writing to you). and you should not have a problem with running into things or running stop signs. and i haven't had a problems since. *jb | |||
| STRUCTURE - BODY - TAILGATE - HINGE AND ATTACHMENTS | |||
| 07/05/2006 | 66000 | 1 | 06/03/2000 |
| Dt*: the contact stated the tailgate cable on the driver's side rusted and broke. the passenger side was also rusted and was about to break. there is an nhtsa recall, # 06v066000 regarding the structure: body: tailgate: hinge and attachments however the vin was not included in the recall. updated 07/25/06. *jb | |||