Bulletins
| Bulletin | Bulletin date | Replacement Bulletin | Item no. | Summary | Added |
|---|---|---|---|---|---|
| POWER TRAIN - AUTOMATIC TRANSMISSION | |||||
| TSB-09-AT-013 | 07/01/2009 | 10030984 | Hyundai: automatic transaxle range switch diagnostic trouble codes p0705 (range switch signal problems), p0707 (range switch open circuit), and p0708 (range switch short circuit or multiple inputs). an improperly adjusted or improperly op | 12/29/2009 | |
Investigations
| NHTSA ID | Manufacturer | Date open | Date close | Subject | Recall campaign | |
|---|---|---|---|---|---|---|
| POWER TRAIN - AUTOMATIC TRANSMISSION - LEVER AND LINKAGE - COLUMN SHIFT | ||||||
| PE09003 | HYUNDAI MOTOR COMPANY | 01/14/2009 | 04/24/2009 | STOP LAMP SWITCH FAILURE | 09V122000 | |
| By letter dated april 15, 2009, hyundai notified the agency that it will conduct a safety recall (nhtsa recall number 09v122) to replace the stop lamp switches on many of its model year 2005-2008 vehicles.see recall 09v122 for a complete list. the agency opened its investigation based on five complaints of stop lamp failure across several 2007 hyundai models. the agency also received early warning (ewr) reports on this issue.most of those failures were traced to the improper operation of the stop lamp switch that controls stop lamp illumination.a malfunctioning stop lamp switch can cause the vehicle's brake lights not to light during braking, or alternatively, it can cause the brake lights to stay lit even when a driver takes the foot off the brake pedal. failure of the stop lamps to illuminate properly creates the hazard of rear end collisions when drivers following the subject vehicle do not recognize that the vehicle is slowing or stopping. hyundai reported one crash incident (a frontal impact), without injury, that was alleged to have been caused by this defect.the agency reviewed the incident and cannot conclude that it is related to this defect. there are other potential problems related to failure of the stop lamp switch: failure of the cruise control to disengage, interference with proper functioning of antilock brakes and electronic stability control, and inability to move the gear shift lever out of park position.based on the above safety recall, this investigation is closed. | ||||||
| POWER TRAIN - AUTOMATIC TRANSMISSION - LEVER AND LINKAGE - FLOOR SHIFT | ||||||
| PE09003 | HYUNDAI MOTOR COMPANY | 01/14/2009 | 04/24/2009 | STOP LAMP SWITCH FAILURE | 09V122000 | |
| By letter dated april 15, 2009, hyundai notified the agency that it will conduct a safety recall (nhtsa recall number 09v122) to replace the stop lamp switches on many of its model year 2005-2008 vehicles.see recall 09v122 for a complete list. the agency opened its investigation based on five complaints of stop lamp failure across several 2007 hyundai models. the agency also received early warning (ewr) reports on this issue.most of those failures were traced to the improper operation of the stop lamp switch that controls stop lamp illumination.a malfunctioning stop lamp switch can cause the vehicle's brake lights not to light during braking, or alternatively, it can cause the brake lights to stay lit even when a driver takes the foot off the brake pedal. failure of the stop lamps to illuminate properly creates the hazard of rear end collisions when drivers following the subject vehicle do not recognize that the vehicle is slowing or stopping. hyundai reported one crash incident (a frontal impact), without injury, that was alleged to have been caused by this defect.the agency reviewed the incident and cannot conclude that it is related to this defect. there are other potential problems related to failure of the stop lamp switch: failure of the cruise control to disengage, interference with proper functioning of antilock brakes and electronic stability control, and inability to move the gear shift lever out of park position.based on the above safety recall, this investigation is closed. | ||||||
| POWER TRAIN - MANUAL TRANSMISSION - COLUMN SHIFT ASSEMBLY | ||||||
| PE09003 | HYUNDAI MOTOR COMPANY | 01/14/2009 | 04/24/2009 | STOP LAMP SWITCH FAILURE | 09V122000 | |
| By letter dated april 15, 2009, hyundai notified the agency that it will conduct a safety recall (nhtsa recall number 09v122) to replace the stop lamp switches on many of its model year 2005-2008 vehicles.see recall 09v122 for a complete list. the agency opened its investigation based on five complaints of stop lamp failure across several 2007 hyundai models. the agency also received early warning (ewr) reports on this issue.most of those failures were traced to the improper operation of the stop lamp switch that controls stop lamp illumination.a malfunctioning stop lamp switch can cause the vehicle's brake lights not to light during braking, or alternatively, it can cause the brake lights to stay lit even when a driver takes the foot off the brake pedal. failure of the stop lamps to illuminate properly creates the hazard of rear end collisions when drivers following the subject vehicle do not recognize that the vehicle is slowing or stopping. hyundai reported one crash incident (a frontal impact), without injury, that was alleged to have been caused by this defect.the agency reviewed the incident and cannot conclude that it is related to this defect. there are other potential problems related to failure of the stop lamp switch: failure of the cruise control to disengage, interference with proper functioning of antilock brakes and electronic stability control, and inability to move the gear shift lever out of park position.based on the above safety recall, this investigation is closed. | ||||||
| POWER TRAIN - MANUAL TRANSMISSION - FLOOR SHIFT ASSEMBLY | ||||||
| PE09003 | HYUNDAI MOTOR COMPANY | 01/14/2009 | 04/24/2009 | STOP LAMP SWITCH FAILURE | 09V122000 | |
| By letter dated april 15, 2009, hyundai notified the agency that it will conduct a safety recall (nhtsa recall number 09v122) to replace the stop lamp switches on many of its model year 2005-2008 vehicles.see recall 09v122 for a complete list. the agency opened its investigation based on five complaints of stop lamp failure across several 2007 hyundai models. the agency also received early warning (ewr) reports on this issue.most of those failures were traced to the improper operation of the stop lamp switch that controls stop lamp illumination.a malfunctioning stop lamp switch can cause the vehicle's brake lights not to light during braking, or alternatively, it can cause the brake lights to stay lit even when a driver takes the foot off the brake pedal. failure of the stop lamps to illuminate properly creates the hazard of rear end collisions when drivers following the subject vehicle do not recognize that the vehicle is slowing or stopping. hyundai reported one crash incident (a frontal impact), without injury, that was alleged to have been caused by this defect.the agency reviewed the incident and cannot conclude that it is related to this defect. there are other potential problems related to failure of the stop lamp switch: failure of the cruise control to disengage, interference with proper functioning of antilock brakes and electronic stability control, and inability to move the gear shift lever out of park position.based on the above safety recall, this investigation is closed. | ||||||
Consumer Complaints
| Fail date | miles | occurences | Purchase date |
|---|---|---|---|
| POWER TRAIN - AUTOMATIC TRANSMISSION | |||
| 09/20/2007 | 3452 | 20 | 08/06/2007 |
| Tl*the contact owns a 2007 hyundai accent. the contact stated that the air bag light was illuminated on the driver side. she took the vehicle to the dealer, but they did not recognize the error codes and just turned off the air bag light. the contact was informed that the vehicle was safe to drive. in december of 2007, the light illuminated again. the service department cleaned the connection and cleared the codes. on january 14, 2008, the failure recurred a third time. the dealer cleared the error codes and ordered parts for the seat belts, which regulated the air bag sensor. the light illuminated again a couple of days later and the dealer installed the part for the sensor. next, the passenger side air bag light began illuminating intermittently. when the contact who is 5'7 and 118 lbs would sit in the passenger seat, the light would illuminate. the dealer stated that they could not provide weight regulations (the weight someone should be for the light not to illuminate). they further stated that they could perform a diagnostic on the vehicle. consumer affairs stated that the air bag sensor should engage at 130-140 lbs, while another representative stated the air bag sensor should engage somewhere between 90 and 120 lbs. another department agreed with consumer affairs regarding the weight. as of january of 2008, there was moisture in the tail lights, which could cause poor illumination. the dealer replaced them, but informed the contact that the failure may recur. in addition, the battery failed and the dealer stated that there was something possibly draining the battery when the vehicle was off. the battery was tested and appeared to be fine. the current mileage was 11,070 and failure mileage was 3,452. updated 05/12/08 *bf the thermostat and gasket were replaced. the check engine light illuminated. there was condensation in both tail lights, a noise was heard when shifting into reverse, there was a rattle/clunk when turning corners. updated | |||