International 9200 2002
Model 9200 made in 2002 by International got 4 recalls as well as 2 service bulletins. Technical service bulletines regarding engine and engine cooling and suspension. There were some recalls concerningelectrical system and equipment.
Model 2002
Recalls
| Campaign | Manufacturer | Manufacturing date | Type | # of units affected | Date Owner notified Mfg | Recall Initiated by | Manufacturers of recalled vehicles/products | Report Recieved Date | Record Creation Date | Regulation Part Number | FMVSS Number | |||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| ELECTRICAL SYSTEM - BATTERY - CABLES | ||||||||||||||||
| 07V020000 | INTERNATIONAL TRUCK & ENGINE CORPORATION | from 04/01/2002 to 12/25/2006 | V (Vehicle) | 21643 | 04/20/2007 | MFR | NAVISTAR, INC | 01/29/2007 | 01/29/2007 | |||||||
| Defect Summary | On certain trucks equipped with caterpillar c10, c11, c12, c13, c15 or c16 engines, the positive battery cables that supply power from the batteries to the starter may rub against an electrical ground cable between the engine and the starter, an electrical ground cable between the frame rail and the starter, or the frame rail itself. | |||||||||||||||
| Consequence Summary | This rubbing may cause an electrical short or a fire which can result in property damage, personal injury or death. | |||||||||||||||
| Corrective Summary | Dealers will inspect the battery cables to determine if any rubbing has occurred. new battery cables will be replaced as necessary. dealers will also reroute the battery cables between the starter and battery box using new brackets. the recall began on april 20, 2007. owners may contact international at 1-800-448-7825. | |||||||||||||||
| Notes | International recall no. 07501.customers may also contact the national highway traffic safety administration | |||||||||||||||
| EQUIPMENT - RECREATIONAL VEHICLE | ||||||||||||||||
| 04V100000 | INTERNATIONAL TRUCK & ENGINE CORPORATION | from 04/01/1994 to 06/16/2002 | V (Vehicle) | 83312 | 07/16/2004 | MFR | NAVISTAR, INC | 02/27/2004 | 03/04/2004 | |||||||
| Defect Summary | On certain conventional trucks equipped with pro-sleeper berths, water intrusion can be found in the bunk control panel area and pool in the tops of the dome light, tv/vcr, and or refrigerator power switches. | |||||||||||||||
| Consequence Summary | The circuit boards in the switches could heat up , possibly produce a flame or fire, and cause property damage, personal injury, or death. | |||||||||||||||
| Corrective Summary | Dealers will install a water shield over the back of the entire bunk control panel. owner notification began on july 16, 2004. owners should contact international at 1-800-448-7825. | |||||||||||||||
| Notes | International recall no. 04503.customers can contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236). | |||||||||||||||
| STEERING - GEAR BOX - SHAFT SECTOR | ||||||||||||||||
| 02V265000 | INTERNATIONAL TRUCK AND ENGINE | from 06/04/2002 to 09/12/2002 | V (Vehicle) | 2129 | 09/27/2002 | MFR | NAVISTAR, INC | 09/25/2002 | 09/26/2002 | |||||||
| Defect Summary | On certain heavy duty trucks, the joint between the lower portion of the steering column and the upper end of the intermediate steering shaft may have a missing or loose pinch bolt. this condition could also occur at the lower end of the intermediate steering shaft at the steering gear connection. | |||||||||||||||
| Consequence Summary | If a pinch bolt is missing or vibrates loose, the shaft could separate from the steering column or steering gear, and /or allow slippage between the joined shafts, increasing the risk of a crash. | |||||||||||||||
| Corrective Summary | Dealers will inspect both ends of the shaft to ensure the pinch bolt is installed and/or properly torqued. if the bolt and nut are missing, a new bolt, nut, and washer will be installed. owner notification is expected to begin during september 2002. owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact international at 1-800-448-7825. | |||||||||||||||
| Notes | Also, customers can contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236). | |||||||||||||||
| SUSPENSION - FRONT - CONTROL ARM - LOWER ARM | ||||||||||||||||
| 04V482000 | INTERNATIONAL TRUCK & ENGINE CORPORATION | from 11/01/2002 to 05/28/2003 | V (Vehicle) | 20 | 11/19/2004 | MFR | NAVISTAR, INC | 10/07/2004 | 10/13/2004 | |||||||
| Defect Summary | On certain heavy duty trucks,the lower tie rod arms on certain axles were not induction hardened as required by international's specification. | |||||||||||||||
| Consequence Summary | Without the induction hardening process being performed, the tie rod arm may fatigue during the expected life of the vehicle. a fatigue failure of the tie rod arm may result in a loss of vehicle steering control that can possibly result in a vehicle crash. | |||||||||||||||
| Corrective Summary | Dealers will inspect and replace the lower tie rod arms. the recall began on november 19, 2004. owners should contact international truck and engine at 1-800-448-7825. | |||||||||||||||
| Notes | International recall no. 04517.customers can also contact the national highway traffic safety administration | |||||||||||||||
Bulletins
| Bulletin | Bulletin date | Replacement Bulletin | Item no. | Summary | Added |
|---|---|---|---|---|---|
| ENGINE AND ENGINE COOLING - ENGINE - GASOLINE - BELTS AND ASSOCIATED PULLEYS | |||||
| 0335 | 12/18/2003 | 0335R | 10003318 | Fan belt and auto tensioner failures on cummins isx 02 emission engines. *tt | 10/16/2003 |
| SUSPENSION - MULTIPLE AXLE - TORQUE ARM | |||||
| AFC-08914 | 02/01/2009 | 10028726 | Navistar: mislocated torque rod bracket on certain prostar and 9000 models. requires an inspection to determine if the torque rod bracket was mislocated on dana 40k and 46k tandem axles. model years unknown. *pe | 05/20/2009 | |