International Harvester 5000 1995

Model 5000 made in 1995 by International Harvester got 2 recalls as well as 1 service bulletin. Technical service bulletines regarding equipment. There were some recalls concerningservice brakes, air and steering.

Model 1995

Recalls


CampaignManufacturerManufacturing dateType# of units affectedDate Owner notified MfgRecall Initiated byManufacturers of recalled vehicles/productsReport Recieved DateRecord Creation DateRegulation Part NumberFMVSS Number
SERVICE BRAKES, AIR - SUPPLY - HOSES, LINES/PIPING, AND FITTINGS
95E003003INTERNATIONAL TRUCK AND ENGINEfrom 03/01/1993 to 03/01/1995E (Equipment)4947ODIINTERNATIONAL TRUCK & ENGINE CORPORATION03/22/199509/27/1995
Defect SummaryAir system blockage in the air dryer occurs degrading the moisture removing capabilities of the dryer when the vehicle is operated in a cold environment and moisture accumulates and freezes in the air dryer or in the line between the dryer and the air system reservoir. the air dryer can become over pressurized causing the air dryer cartridge to separate from the mounting base.
Consequence SummaryIf the air dryer separates from the base, the cartridgecan separate sufficiently enough to cause personal injury or property damage.
Corrective SummaryDealers will equip air systems with a pressure relief valve to be located between the compressor and the air dryer. this pressure relief valve is intended to vent if excessive pressure develops in the air dryer.
NotesSystem: brakes;air dryer. vehicle description: medium and heavy duty trucks and buses equipped with rockwell wabco system saver 1000 or system saver twin air dryers.note: if your vehicle is presented to an authorized dealer on an agreed upon service date and the remedy is not provided free of charge with in a reasonable time, contact navistar international at 1-800-448-7825.also contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393.
STEERING - LINKAGES - TIE ROD ASSEMBLY
95E009002INTERNATIONAL TRUCK AND ENGINEfrom 03/01/1995 to 03/01/1995E (Equipment)196MFRINTERNATIONAL TRUCK & ENGINE CORPORATION05/09/199510/10/1995
Defect SummaryDuring assembly, the tie rod end nuts were not properly torqued. extremely low torque can allow movement beween the ball stud and the tie rod arm causing damage.
Consequence SummaryThis condition can affect the driver's ability tosteer the vehicle increasing the potential for a vehicle accident.
Corrective SummaryDealers will check the torque on the ball studs of the suspect axles and bring the torque up to rockwell's specifications.
NotesSystem: steering; linkages; tie rod; end.vehicle description: medium and heavy duty trucks equipped with rockwell non-driving front axles, models ff-942, ff-961 or fl-941.note: if your vehicle is presented to an authorized dealer on an agreed upon service date and the remedy is not provided free of charge within a reasonable time, please contact navistar at 1-800-448-7825. also contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393.

Bulletins


BulletinBulletin dateReplacement BulletinItem no.SummaryAdded
EQUIPMENT - ELECTRICAL - AIR CONDITIONER
BCM950001602/01/199539346Improved air conditioner mounting brackets for l10 and m11. *tw11/01/1995