International Re Bus 2003

Model Re Bus made in 2003 by International got 2 recalls as well as 9 service bulletins. Technical service bulletines regarding electrical system and latches/locks/linkages. There were some recalls concerningsteering and vehicle speed control.

Model 2003

Recalls


CampaignManufacturerManufacturing dateType# of units affectedDate Owner notified MfgRecall Initiated byManufacturers of recalled vehicles/productsReport Recieved DateRecord Creation DateRegulation Part NumberFMVSS Number
STEERING - HYDRAULIC POWER ASSIST - PUMP
04V250000INTERNATIONAL TRUCK & ENGINE CORPORATIONfrom 02/03/2003 to 01/22/2004V (Vehicle)599906/29/2004ODINAVISTAR, INC05/27/200405/27/2004
Defect SummaryOn certain school and transit buses the studs used to secure the power steering pump to the engine block can fail, resulting in engine oil leakage and complete loss of power steering. the power steering pump is designed to provide power assist to both the steering system and the hydraulic braking system. should stud failure cause the pump to become disengaged from its drive gears, a reduction of the fluid flow rate to the brake system could occur and possibly cause an extended stopping distance as well as increased steering wheel efforts.
Consequence SummarySudden loss of power steering will impair the vehicle operator, possible resulting in a vehicle crash.
Corrective SummaryInternational will notify its customers and all vehicles will be inspected and any suspect studs will be replaced. owner notification began september 24,2004. owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact international at 1-800-448-7825.
NotesAlso, customers can contact the national highway traffic safety administration
VEHICLE SPEED CONTROL
02V004010INTERNATIONAL TRUCK AND ENGINEfrom 02/07/1994 to 08/21/2002V (Vehicle)3114512/16/2002MFRNAVISTAR, INC09/20/200209/25/2002
Defect SummaryOn certain school and transit buses equipped with electronic throttle control/accelerator pedals supplied by williams controls industries, the weld attaching the clevis to the plate has insufficient penetration and could allow the clevis to separate from the plate.
Consequence SummaryIf the clevis separated from the plate while the vehicle was in use, the vehicle would return to idle, increasing the risk of a crash.
Corrective SummaryInternational will retrofit vehicles with a new pedal rod and bracket. owner notification began december 16, 2002. owners who do not receive the free remedy within a reasonable time should contact international at 1-800-448-7825.
NotesAlso contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).

Bulletins


BulletinBulletin dateReplacement BulletinItem no.SummaryAdded
ELECTRICAL SYSTEM
IK-220011706/04/201210044297International: information provided regarding procedure to replacing and adjusting electric door drive motor on buses. *pe06/06/2012
LATCHES/LOCKS/LINKAGES - DOORS - LATCH
IK-220011606/04/201210044296International: air door has bent adjustment rods, pook link arm clearance, opens due to highway speeds or cross winds, water leaks, fails to close. while electric door has similar issues, motor failure, water leaks, header box fit, pook li06/06/2012
(PWS)
IK-080021906/04/201210044293International/navistar: a new design aps sensors (accelerator position sensor) has been developed to replaced open/closed ivs switches in old sensors. *pe06/06/2012
STRUCTURE - BODY - DOOR
IK-220011706/04/201210044297International: information provided regarding procedure to replacing and adjusting electric door drive motor on buses. *pe06/06/2012
IK-220011606/04/201210044296International: air door has bent adjustment rods, pook link arm clearance, opens due to highway speeds or cross winds, water leaks, fails to close. while electric door has similar issues, motor failure, water leaks, header box fit, pook li06/06/2012
SB-IK-2200069-508/08/201110041400Navistar: forward door bracket pulled loose from the door. improper adjustment, loose attachment bolts, or an obstruction limiting door travel are the most common cause. *rm09/28/2011
SB-IK-2200069-508/08/201110041400Ready09/28/2011
STRUCTURE - BODY - DOOR - HINGE AND ATTACHMENTS
IK-220011606/04/201210044296International: air door has bent adjustment rods, pook link arm clearance, opens due to highway speeds or cross winds, water leaks, fails to close. while electric door has similar issues, motor failure, water leaks, header box fit, pook li06/06/2012
VISIBILITY - POWER WINDOW DEVICES AND CONTROLS
IK-220006001/24/200810032287International bus: bus, passenger window plastic guide. passenger split sash windows that are hard to slide and exhibit latching issues may have the plastic slide broken loose and out of position causing the window to bind. windows are h03/01/2010