Investigations


NHTSA IDManufacturerDate openDate closeSubjectRecall campaign
VEHICLE SPEED CONTROL - LINKAGES
PE90001FORD MOTOR COMPANY10/04/198902/02/1990THROTTLE STICKING
 There is no summary currently available
PE93075FORD MOTOR COMPANY08/30/199312/30/1993THRTTL VLV LINKAGE BUSHING
 There is no summary currently available
EA90009FORD MOTOR COMPANY02/08/199002/28/1991THROTTLE STICKING
 There is no summary currently available
EA93033FORD MOTOR COMPANY12/30/199312/30/1994THRTTL VLV LINKAGE BUSHING
 There is no summary currently available

Consumer Complaints


Fail datemilesoccurencesPurchase date
VEHICLE SPEED CONTROL
 No summary
02/02/1999
 Consumer had foot on brake and had vehicle in park when vehicle accelerated at 35 mph and hit a brick wall. consumrer doesn't have a vehicle any more. *ak
1
 Vehicle experienced sudden acceleration (attorney for consumer).
10/08/199810/15/1992
 Vehicle wa sparked, facing uphill on a 75 foot long downward sloping driveway of asphalt. started vehicle and it suddenly revved and accelerated violently rearward. vehicle raced backward, down drive, toward street. driver tried to stop with brakes, but they only slowed vehicle a bit. fearing that vehicle would race into street, swung steering wheel to left, to put vehicle on lawn. rea rof vehicle swung into parke dvehicle, knocking it forward and damaging rear. vehicle then bounced sideways into drive and attempted to climb a hill. killed ignition to stop. driver sustained back injuries and had a headache. .
05/25/1997105/18/1989
 Sudden acceleration when started, causing accident.
06/09/1997
 When starting the car and shifting into drive with the foot on the brake, it could not be stopped. the accelerator was on the floor by itself. the car had to be turned off.
01/20/1997
 While driving pressed on the accelerator pedal and there was sudden acceleration to 75 mph; also, tapped on the brakes and the vehicle went in neutral. manufacturer said the transmission cable bushing broke, causing the accelerator to jam. *ak
1
 Throttle linkages and control problem. (2nd vehicle on 601564/503665)
07/25/1996109/01/1995
 Turned on ignition, shifted from park to drive, engine accelerated to high speed, picked up more speed with foot on brakes, stopped after hitting brick house, no prior warning.*ak
03/07/19967
 Sudden acceleration. *dh
04/12/1996
 Cruise control failure, driver experienced acceleration of speeds from 45-55 mph to approximately 70 mph. *ak
07/21/19951
 Consumer got in car started it up and it went dead, started it up again and put into reverse with foot on brake, car accelerated backward . tt
05/20/19951
 Engaged in reverse, vehicle suddenly accelerated into a wall, then engaged in drive, vehicle suddenly accelerated out of control, resulting in an accident. *ak
06/10/1995
 Had vehicle accident because throttle sticking wide open. *ak
05/20/19951
 Plastic clip to throttle valve broke causing tubing to get caught in accelerator spring mechanism;jammed accelerator, engine accelerated;froze at 50 mph. *ak
VEHICLE SPEED CONTROL - ACCELERATOR PEDAL
 During normal pedal operation pedal will stick, causing erratic acceleration. please describe. *ak
08/19/1995
 Consumer was driving and the gas pedal stuck to the floor(accelerate) to avoid hitting car consumer went off the road and totaled car . tt
VEHICLE SPEED CONTROL - CABLES
05/27/2003205060107/27/1990
 While driving the vehicle the plastic block that connects the throttle valve (tv) cable to the throttle lever broke where it connects to the throttle lever. the plastic block, still connected to the tv cable, dropped down and wedged between the throttle lever and a fuel rail and prevented the throttle level from going back to the normal idle position. when approching stopped traffic at an intersection the partially open throttle prevented the vehicle from stopping as usual and a collision resulted. when restarting the vehicle after the accident the engine idled at 3000 rpm. when the plastic tv cable block was unwedged from between the throttle lever and the fuel rail the engine idle speed was back to the normal 900 rpm.
VEHICLE SPEED CONTROL - CRUISE CONTROL
03/01/1989103/01/1989
 Idle speed control valve failed twice.
VEHICLE SPEED CONTROL - LINKAGES
05/27/2003205060107/27/1990
 While driving the vehicle the plastic block that connects the throttle valve (tv) cable to the throttle lever broke where it connects to the throttle lever. the plastic block, still connected to the tv cable, dropped down and wedged between the throttle lever and a fuel rail and prevented the throttle level from going back to the normal idle position. when approching stopped traffic at an intersection the partially open throttle prevented the vehicle from stopping as usual and a collision resulted. when restarting the vehicle after the accident the engine idled at 3000 rpm. when the plastic tv cable block was unwedged from between the throttle lever and the fuel rail the engine idle speed was back to the normal 900 rpm.
06/01/19970
 Consumer son was driving about 20-25 mph when suddenly the vehicle started to pick up speed, hitting 45 mph, lost control of car, engine locked up, shift gear got stuck. due to this defect, consumer had to hit the vehicle in front in order to stop. *ak
04/05/199609/01/1989
 Vehicle was in idle position in park, put in gear into drive, vehicle went into open throttle position, pedal went the floor, tried to brake, rpms unknown, impact 12:00 position, hitting a parked vehicle. also, cruise control malfunctioned. *ak