Bulletins


BulletinBulletin dateReplacement BulletinItem no.SummaryAdded
ENGINE AND ENGINE COOLING - COOLING SYSTEM - RADIATOR ASSEMBLY
9515307/01/199545934Temperature gauge - fluctuating and /or inaccurate high readings. *sd04/25/1996
ENGINE AND ENGINE COOLING - ENGINE
987404/13/1998601343A new silicone gasket and sealant. *yc07/24/1998
9761003/17/199751990Blower motor- chirping or squeaking from blower motor at low speeds. *jd07/17/1997
956803/01/199539904Revised oil pan gasket. *tw11/01/1995
BC889995040104/01/19953030300Unknown11/01/1995
ENGINE AND ENGINE COOLING - ENGINE - GASOLINE
9981605/03/1999606420Ford motor company now recommends sae 5w-30 viscosity grade for servicing any ford gasoline-powered vehicle regardless of model year. *tt08/19/1999
ENGINE AND ENGINE COOLING - EXHAUST SYSTEM
986403/30/1998601312Information on a buzzing or rattle noise from the exhaust system. *tt07/21/1998
ENGINE AND ENGINE COOLING - EXHAUST SYSTEM - EMISSION CONTROL
98231011/23/1998603724Mass air flow (maf)- sensor contamination- service tip. *ak03/03/1999

Consumer Complaints


Fail datemilesoccurencesPurchase date
ENGINE AND ENGINE COOLING - ENGINE
1
 The vehicle's camshaft sensor failed and was replaced . *yh
01/30/200101/01/2001
 Heads/head gaskets had caused vehicle to over-heat as well as shut itself down during motion. problem were brought to the attention of howard pontiac dealership as well as president, the following day used car manager dean schulatz had offered to make another even trade with me to a oldsmobile acheiva so he could put the vehicle i were currently operatting back in service and do the repair work needed to make it a safe vehicle for the road, but upon finding out that i have put this vehicle in a private repair shop he had declined to come forth with the money to do the repair work ,he would have found if he had serviced thisvehicle prior to the sale of this vehicle.*ak
09/20/19971
 The head gasket failed causing water and anit-freeze to leak into the motor, causing the vehicle to have no heat. slc
04/03/2000206/01/1994
 Thie 3.8 eng is the same as the recalls on other ford vehicle. *ak
01/23/2000109/01/1992
 Engine head gasket failure at 75k miles. former ford mechanic stated he had repaired hundreds of these 3.8 head gasket failures. new shop specs for repair were for tighter torque than done at factory and replace engine bolts with larger ones. he felt it should have been a recall item, since it wasn't properly done at factory. have not had repairs done yet. is there an investigation pending on this situation and/or possible recall being prepared? thank you. *ak
01/01/1999
 Reporting a blown engine head gasket on a 3.8l engine, which was repaired by a independent repair shop at consumer's cost. asking nhtsa to look into this matter. too many complaints & report on this blown head gaskets for 3.8l engine. we are calling for help. *ak
 Gaskets deteriorated on one portion where the head and gasket meet. replaced head gaskets and bolts on both sides. *ak
07/29/19960
 Driver entered vehicle, put on lap/shoulder belt, put vehicle in drive position, suddenly vehicle accelerated and took off, tried to apply brakes, which did not work, driver steered vehicle towards a wall, vehicle was totaled.*ak
ENGINE AND ENGINE COOLING - ENGINE - GASOLINE
05/10/19991
 Engine fire. mjs