Consumer Complaints


Fail datemilesoccurencesPurchase date
SEATS
11/05/201252000
 Tl-the contact owns a 2007 mercury mountaineer. while driving approximately 40 mph, the front driver's side seat moved backward and forward independently. the vehicle was taken to the dealer for diagnostic testing. the technician was able to duplicate the failure and recommended replacing the ignition. the technician advised that if the failure continued, then the seating harness would have to be replaced. the contact had the technician disconnect the seat. the vehicle was not repaired. the approximate failure mileage was 52,000. kmj
11/05/201252000
 Tl-the contact owns a 2007 mercury mountaineer. while driving approximately 40 mph the front driver side seat slid backwards and forward on its own. the vehicle was taken to the dealer for diagnostic testing. the technician was able to duplicate the failure and recommended replacing the ignition. the technician stated if the failure continued the seating harness may have to be replaced. the contact had the technician disconnect the seat. the vehicle was not repaired. the approximate failure mileage was 52,000. da
11/18/2011
 In regards to fitting two backless booster seats in the middle row of a 60-40 fold bench: on the passenger side- the seat does not slope on the sides and the buckle has a cloth strap and it is flexible and moves out of the slot to fit to his buckle. the seat is slightly wider than the drivers side. driver's side- the seat is more contoured and the buckle is affixed to the seat and does not move or come up because of the 60-40 split. when the booster seat is placed out of the edge of the contour on the drivers side- it completely covers the buckle. therefore, one must sit the booster unsafely at an angle where one side is higher than the other to get the buckle to fit in. i am certain in the event i slam on my brakes or get rearended, one child's seat would go flying, whereas the other seat fits safe and secure (passenger side).