Recalls
Campaign | Manufacturer | Manufacturing date | Type | # of units affected | Date Owner notified Mfg | Recall Initiated by | Manufacturers of recalled vehicles/products | Report Recieved Date | Record Creation Date | Regulation Part Number | FMVSS Number | |||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DIFFERENTIAL PROPORTIONAL VALVE | ||||||||||||||||
90V145000 | CHRYSLER CORPORATION | from 03/01/1990 to 03/01/1990 | V (Vehicle) | 100 | 09/24/1990 | MFR | CHRYSLER GROUP LLC | 08/10/1990 | 08/23/1990 | |||||||
Defect Summary | Incorrect screws may have been used in installing the load sensing brake proportioning valve to its bracket causing the clamping load to be less than intended. | |||||||||||||||
Consequence Summary | This could result in inconsistent front to rear brakebalance with potential for rear brake skid under heavy braking conditions. | |||||||||||||||
Corrective Summary | Replace proportioning valve to bracket screws with proper length screws. | |||||||||||||||
Notes | System: brakes; proportioning valve screw.vehicle description: truck van. |
Consumer Complaints
Fail date | miles | occurences | Purchase date |
---|---|---|---|
SERVICE BRAKES, HYDRAULIC - ANTILOCK | |||
10/17/1999 | 7 | 01/01/1995 | |
Have gone to dealership numerous time for the anti-brake problem....good for a month and the problem arise again. *ak | |||
10/06/1992 | |||
While driving at 30 mph and over and attempting to apply the brakes, vehicle would not stop and slid, causing extended stopping distance. *ak | |||
06/27/1996 | |||
The abs brakes do not stop the van. when coming to a stop, the pedal goes to the floor and will not stops. please describe. *ak | |||
08/12/1995 | 2 | ||
Anti-lock brakes failed, resulting in extended stopping distance. *ak | |||
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS | |||
6 | 05/25/1995 | ||
Brakes failed. | |||
11/29/1995 | 9 | ||
Front brakes wear uneven. *sd | |||
Brakes fail causing consumer to rear end person in front of him. tt | |||
10/13/1994 | 3 | ||
Brake leak. | |||
Had to replace brake system three times because pedal would go to floor. tt | |||
Consumer was driving and the brake fluid was leaking there was no warning of the brake purchase car used . tt | |||
06/12/1993 | |||
Brakes slow to catch; seems to hold back; pedal went to floor; caused accident. tt | |||
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DIFFERENTIAL PROPORTIONAL VALVE | |||
06/07/1995 | 7 | ||
Continuous brake repairs/problems/squeak after recall repair (90v-145). *skd | |||
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC | |||
1 | |||
Noisy front brakes. | |||
Left front brake locks up. tt | |||
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DRUM | |||
Rear brakes locke dup. also leaking windshield. *ak | |||
12/11/1995 | 1 | ||
Rear brakes lock up, on moderate to hard stops. *sd | |||
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DRUM - WHEEL CYLINDERS | |||
12/03/1995 | 3 | ||
Piston seals on both rear brakes blew out, causing loss of all fluid/complete brake failure/accident. *dsh | |||
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - HOSES, LINES/PIPING, AND FITTINGS | |||
03/01/1997 | 09/01/1989 | ||
Brake hose suddenly ruptured at rear side of hose from crack, no apparent damage. *ak | |||
12/15/1996 | |||
Non metallic brake hose; front brake hoses failed at mounting bracket due to improper bracket design. when applying brakes, the pedal goes completely to the floor and there are no brakes, all the fluid comes out. *ak | |||
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - MASTER CYLINDER | |||
06/22/1994 | 1 | ||
Brake master cylinder replaced. *skd |