Bulletins


BulletinBulletin dateReplacement BulletinItem no.SummaryAdded
SERVICE BRAKES, HYDRAULIC - POWER ASSIST
97050173501905/01/199753015When brakes are depressed force or engine load may affect and cause various noises. *yc11/06/1997

Consumer Complaints


Fail datemilesoccurencesPurchase date
SERVICE BRAKES, HYDRAULIC
08/05/200339000709/12/1997
 Consumer stated while driving vehicle at 25 mph suddenly all electrical components died. no brakes/ no power steering. took vehicle to dealer, dealer popped hood, and noticed battery acid all over the engine compartment, and battery cables were loose. dealer replaced cables, and put jelly around them. five days later, cables were loose again. cause unknown. the cable has loosen again and vehicle stalled and lost all power. consumer was left stranded. *ak
SERVICE BRAKES, HYDRAULIC - ANTILOCK
06/01/2000
 No summary listed for above vehicle. *ak
11/16/2000109/01/1999
 I was driving home from when work when my car caught on fire. my brakes stopped working and i was unable to stop the car. the car was engulfed in flames in the matter of a few minutes. *ak
06/28/20000
 After inspecting the brakes, noticed unusual wear on the side of the brake rotors, they could deteriorate. *ak
07/15/19985
 Abs: brake pedal very hard. not stopping vehicle. pedal at times goes to floor. took to dealer. not able to find brake problem, or unable to duplicate. *ak
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS
12/01/2001
 Brakes make noise when applying them. also, there is extended stopping distance. please provide more information. *ak
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC
02/10/2002
 When applying brakes at highway speeds vehicle and steering wheel vibrate, causing driver to have minimal control over vehicle. dealer has seen 4 or 5 times vehicle, but problem still exists. *ak
02/01/1998205/01/1997
 The problem started with a thumping sound coming from the front/brake area of the vehicle. after attempting to pull out of the shopping center i realized my brakes were gone. my husband was able to get it to rapid motors the next day and we were told that the master cylinder would have to be replaced. just over 1 year later the same problems started again and again the brakes went out and we were told again a new master cylinder would need replacing. each replacement has cost us a little over $300.00. i understand it may be time to replace brake pads but i don't that is the only problem with the master cylinder not being able to last more than 1 year. the invoice for repair of the last master cylinder states: found brake pedal goes to floor, checked for leaks, non found, checked vacuum - ok. master cylinder leaking internal. removed master cylinder and installed new one. bled brakes sytem, test drove, working to factory specs. to summarize, the original master cylinder and a second master cylinder have been replace within the 2 1/2 years that i have owned this vehicle. please let me know if you need additional information. *ak
11/28/1997108/19/1997
 Consumer heard a metal to metal grinding noise. went to dealer where they replaced rotors/pads to front wheels. *ak dealer stated the brake rotors on the outside surface were blackened from heat and the brake pads were glazed. *slc
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - ROTOR
06/28/20000
 After inspecting the brakes, noticed unusual wear on the side of the brake rotors, they could deteriorate. *ak
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - HOSES, LINES/PIPING, AND FITTINGS
08/17/200644000108/08/1997
 Dt*: the contact stated the hydraulic brake lines were corroded at every connection. the vehicle was taken to the dealership who determined the brake fluid was leaking due to the corrosion. the dealership informed the contact there were 10-15 other vehicles with the same problem. updated 9/5/2006 - *nm
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - MASTER CYLINDER
205/01/1997
 No summary listed for above vehicle. *ak
02/01/1998205/01/1997
 The problem started with a thumping sound coming from the front/brake area of the vehicle. after attempting to pull out of the shopping center i realized my brakes were gone. my husband was able to get it to rapid motors the next day and we were told that the master cylinder would have to be replaced. just over 1 year later the same problems started again and again the brakes went out and we were told again a new master cylinder would need replacing. each replacement has cost us a little over $300.00. i understand it may be time to replace brake pads but i don't that is the only problem with the master cylinder not being able to last more than 1 year. the invoice for repair of the last master cylinder states: found brake pedal goes to floor, checked for leaks, non found, checked vacuum - ok. master cylinder leaking internal. removed master cylinder and installed new one. bled brakes sytem, test drove, working to factory specs. to summarize, the original master cylinder and a second master cylinder have been replace within the 2 1/2 years that i have owned this vehicle. please let me know if you need additional information. *ak