Bulletins


BulletinBulletin dateReplacement BulletinItem no.SummaryAdded
STRUCTURE - BODY - TRUNK LID
AX0010103/09/2001619097Technical service bulletin regarding retro-fit internal trunk release kits. *tt05/14/2001

Consumer Complaints


Fail datemilesoccurencesPurchase date
STRUCTURE - BODY
 Paint is peeling from vehicle.
STRUCTURE - BODY - DOOR
08/15/1999
 Automatic door on the driver's side locks intermittently. when getting out of vehicle only on the driver's side locks up. *ak
07/15/1996
 Vehicle was inspected and discovered by dealer shop of both rear doors were melting for unknown reason. dealer informed consumer vehicle was not under any warranty, and repair would be at consumer expense. consumer seeking help from nhtsa in this matter. *ak
2
 Power door locks fail intermittently, warning lights on the dashboard light up intermittently.
10/14/19944
 Power door locks failed prior to/after recall repairs. *ak
02/14/19954
 Power door locks failed.
04/11/19951
 Power window failure. *tw
STRUCTURE - BODY - DOOR - HINGE AND ATTACHMENTS
10/21/200610006/05/2003
 The doors always fall back shut when opened, even when the car is parked on a perfectly flat surface. i have struggled with the door many times while trying to get out of the car, because it swings back closed before i can move. today it finally bashed me on the shin when i opened the door and reached in to get something from the center console. *nm
STRUCTURE - BODY - HOOD
10/23/20021
 Traveling on interstate highway at 65mph, hood released, flipped against windshield. hood struck roof, and landed in roadway. no previous malfunction of hood latch or safety catch. no prior warning of problem, hood was separated from vehicle. hood and vehicle are available for inspection if needed. dt
10/03/2001308/01/1998
 Mechanism supporting hood failed. there is no backup support, such as a rod, that holds up the hood. hood slammed closed on consumer's hand, causing injury.*ak
04/04/1996311/01/1995
 Tires had very uneven and premature wear, caused by improper rear end alignment. cooling system overheated, and did not have a system that shuts the engine down in order to protect engine components. thus, the engine on my vehicle overheated and damaged the head gasket, water pump, and timing belt. each had to be replaced. the power window regulator has failed on all but one window, ritht rear, of my car. i have spoken to other owners of 1993-94 toyota camrys who have experienced the same problem. i believe that the design of this regulator is severly flawed.( dot number: )
1
 When lifting the hood, the engine hood support failed. *ak consumer states when raised, the hood falls down, sometimes immediately fell on mechanic's head when oil was being changed.*jb
 While driving, at approx. 55mph, suddenly hood fly up. tt
108/17/1993
 While driving, at approx. 55mph, suddenly hood flew up and detached from vehicle, for no apparent reason. tt *slc
STRUCTURE - BODY - HOOD - HINGE AND ATTACHMENTS
09/15/1996
 Engine hood support does not hold up hood, especially during cold weather, hood came down on three separate occasions. *ak
08/01/1996104/29/1993
 Hood support failed to hold hood in open position.
10/24/1995108/01/1993
 Engine compartment hood support failure, the hood will not stay in the up position, pe96-040. *ak
08/19/1996
 Failure on engine compartment hood support, the hood will not stay in the up position pe96-040.
04/09/19969
 Hood hinges/safety latch failed, allowing hood to blow off vehicle. *dh
STRUCTURE - BODY - TRUNK LID
11/27/1998109/01/1997
 I am talking about what holds the hood up will fall after a minute and there is no manual stick to hold it up, there were no injuries, i tried this procedure three times
04/20/1995
 Trunk lid falls down hitting person leading into truck due to defective spring hinges. please describe details. tt