Bulletins


BulletinBulletin dateReplacement BulletinItem no.SummaryAdded
ENGINE AND ENGINE COOLING
SI B12 55 0601/01/201110037700Ready06/03/2011
SI B12 55 0601/01/201110037700Bmw: there may be excessive cranking before the vehicle starts. the service engine soon light may also be on with a lack of engine power. *rm06/03/2011
ENGINE AND ENGINE COOLING - ENGINE
SIB-61-07-1202/01/201210043689Bmw: after a few miles or several thousand miles, check control message, hybrid malfunction, may appear after programming of software for vehicle. *pe04/20/2012
SIB-12-15-0512/01/200710032990Bmw: diagnosis of dme me 9.2 map thermostat fault 2ef4/279b. the service engine soon light illuminated. the engine does not overheat and the map thermostat operates properly. possible causes are deterioration of coolant quality; increas06/21/2010
SIB-12-26-0910/01/200910032646Bmw vehicles: edk throttle potentiometer faults-diagnosis. models e60, e63, e64, e65, e66, and e70. the service engine soon and dsc/dtc warning lamps are illuminated. the engine enters the power reduction (fail safe) mode. *pe04/23/2010
SI-B12-11-0904/01/200910029604Bmw: vehicle may intermittently exhibit any of the following: hard to start or may not start; engine runs rough and lacks or loses power; engine power reduced. vapor lock in the fuel system could occur under certain engine operating conditi07/13/2009
ENGINE AND ENGINE COOLING - ENGINE - DIESEL
SIB-12-26-0910/01/200910032646Bmw vehicles: edk throttle potentiometer faults-diagnosis. models e60, e63, e64, e65, e66, and e70. the service engine soon and dsc/dtc warning lamps are illuminated. the engine enters the power reduction (fail safe) mode. *pe04/23/2010
ENGINE AND ENGINE COOLING - EXHAUST SYSTEM - EMISSION CONTROL
SI-B12-15-1010/01/201010036911Bmw: voluntary emissions recall campaign 10e-a01: program control units (dme retrofit). an error in dme (digital motor electronics) software, it may not be possible to read out the dme data using a non bmw tester (i.e., scan tool, etc.).04/18/2011

Consumer Complaints


Fail datemilesoccurencesPurchase date
ENGINE
10/08/201299500
 Tl* the contact owns a 2005 bmw 7 series. the contact stated that he was unable to pass emissions because the check engine warning light was illuminated. the contact took the vehicle to the dealer and was told that the intake valves on the auxiliary pump leaked oil into the manifold and caused the vehicle to release smoke and emissions. the failure mileage was 99,500 and the current mileage was 101,100.
10/08/201299500
 Tl- the contact owns a 2005 bmw 7 series. the contact stated that he was unable to pass emissions because the check engine warning light was illuminated. the contact took the vehicle to the dealer and was told that the intake valves on the auxiliary pump leaked oil into the manifold and caused the vehicle to release smoke and emissions. the failure mileage was 99,500 and the current mileage was 101,100. kmj
10/08/201299500
 Tl- the contact owns a 2005 bmw 7 series. the contact stated that was unable to pass emmission because of the check engine light was on the instrument panel. the contact took the vehicle to the dealer and was told the intake valves on the auxilary pump leaked oil into the manifold and caused the vehicle to smoke and release to many emmissions. the failure mileage was 99,500 and the current mileage was 101,100.rl