Bulletins


BulletinBulletin dateReplacement BulletinItem no.SummaryAdded
EXTERIOR LIGHTING
SIB-63-02-0108/01/201010037025Ready04/27/2011
SIB-63-02-0108/01/201010037025Bmw: procedure for determining and replacing incandescent and halogen light bulbs under warranty. *rm04/27/2011

Investigations


NHTSA IDManufacturerDate openDate closeSubjectRecall campaign
EXTERIOR LIGHTING
EA09019BAYERISCHE MOTOREN WERKE12/18/2009REAR LAMP ILLUMINATION
 The outboard rear light assembly consists of a turn signal lamp, a tail lamp and a brake lamp.failure of the light assembly ground circuit results in loss of all three lamps.bmw submitted complaint and warranty information showing a significant number of rear lamp assembly failures due to an open ground connection at the eight pin connector of the light assembly.this results in the loss of the rear turn signal.overheating of the ground circuit electrical pin, possibly due to increased resistance and or high current flow, is indicated in some failures.additionally bmw issued a technical service bulletin (tsb) sib-630306 in february 2007 to address the condition by adding supplementary ground wiring to the tail lamp assembly.the additional ground wire added by the procedure reduces the current flow at the eight pin connector.odi is opening this ea to further investigate the issue.
PE09036BAYERISCHE MOTOREN WERKE08/07/200912/22/2009REAR LAMP ILLUMINATION
 Odi has received complaints from consumers stating that their tail light assembly is not properly illuminating.the tail light assembly consists of a turn signal lamp, a tail lamp and a brake lamp.the complainants have indicated that the issue is with an 8 pin connector and associated ground wiring.these components are allegedly overheating and melting due to excessive electrical current that runs through the system.bmw issued a technical service bulletin (tsb) sib-630306 on february 2007 to address the condition by adding supplementary ground wiring to the tail lamp assembly.odi is upgrading to an ea to further investigate the issue.
DP09002BAYERISCHE MOTOREN WERKE04/08/200908/06/2009REAR LAMP ILLUMINATION
 In march 2009, the office of defects investigation (odi) received a petition from mr. mark peters requesting an investigation of rear lamp failure in model year 2002-2005 bmw 3-series vehicles.an information request letter was sent to bmw in april 2009, and odi received bmw's response in june 2009.the tail lamp assembly contains lighting for the brake lamps, tail lamps, and turn signals.a technical service bulletin (tsb) was issued by bmw in january of 2007 instructing service technicians to examine an 8 pin electrical connector for heat-related damage and to incorporate additional ground wiring to the connector.complainants have alleged that significant thermal damage to the connector and associated ground wiring has occurred.this condition can result in intermittent or total loss of all lighting (brake, tail, and turn signal) for the effected rear lamp assembly.odi will open a preliminary evaluation to further examine this issue including further evaluating bmw complaints and related warranty data.
EXTERIOR LIGHTING - BACK UP LIGHTS
DP09002BAYERISCHE MOTOREN WERKE04/08/200908/06/2009REAR LAMP ILLUMINATION
 In march 2009, the office of defects investigation (odi) received a petition from mr. mark peters requesting an investigation of rear lamp failure in model year 2002-2005 bmw 3-series vehicles.an information request letter was sent to bmw in april 2009, and odi received bmw's response in june 2009.the tail lamp assembly contains lighting for the brake lamps, tail lamps, and turn signals.a technical service bulletin (tsb) was issued by bmw in january of 2007 instructing service technicians to examine an 8 pin electrical connector for heat-related damage and to incorporate additional ground wiring to the connector.complainants have alleged that significant thermal damage to the connector and associated ground wiring has occurred.this condition can result in intermittent or total loss of all lighting (brake, tail, and turn signal) for the effected rear lamp assembly.odi will open a preliminary evaluation to further examine this issue including further evaluating bmw complaints and related warranty data.
EXTERIOR LIGHTING - BRAKE LIGHTS
DP09002BAYERISCHE MOTOREN WERKE04/08/200908/06/2009REAR LAMP ILLUMINATION
 In march 2009, the office of defects investigation (odi) received a petition from mr. mark peters requesting an investigation of rear lamp failure in model year 2002-2005 bmw 3-series vehicles.an information request letter was sent to bmw in april 2009, and odi received bmw's response in june 2009.the tail lamp assembly contains lighting for the brake lamps, tail lamps, and turn signals.a technical service bulletin (tsb) was issued by bmw in january of 2007 instructing service technicians to examine an 8 pin electrical connector for heat-related damage and to incorporate additional ground wiring to the connector.complainants have alleged that significant thermal damage to the connector and associated ground wiring has occurred.this condition can result in intermittent or total loss of all lighting (brake, tail, and turn signal) for the effected rear lamp assembly.odi will open a preliminary evaluation to further examine this issue including further evaluating bmw complaints and related warranty data.
PE09036BAYERISCHE MOTOREN WERKE08/07/200912/22/2009REAR LAMP ILLUMINATION
 Odi has received complaints from consumers stating that their tail light assembly is not properly illuminating.the tail light assembly consists of a turn signal lamp, a tail lamp and a brake lamp.the complainants have indicated that the issue is with an 8 pin connector and associated ground wiring.these components are allegedly overheating and melting due to excessive electrical current that runs through the system.bmw issued a technical service bulletin (tsb) sib-630306 on february 2007 to address the condition by adding supplementary ground wiring to the tail lamp assembly.odi is upgrading to an ea to further investigate the issue.
EA09019BAYERISCHE MOTOREN WERKE12/18/2009REAR LAMP ILLUMINATION
 The outboard rear light assembly consists of a turn signal lamp, a tail lamp and a brake lamp.failure of the light assembly ground circuit results in loss of all three lamps.bmw submitted complaint and warranty information showing a significant number of rear lamp assembly failures due to an open ground connection at the eight pin connector of the light assembly.this results in the loss of the rear turn signal.overheating of the ground circuit electrical pin, possibly due to increased resistance and or high current flow, is indicated in some failures.additionally bmw issued a technical service bulletin (tsb) sib-630306 in february 2007 to address the condition by adding supplementary ground wiring to the tail lamp assembly.the additional ground wire added by the procedure reduces the current flow at the eight pin connector.odi is opening this ea to further investigate the issue.
EXTERIOR LIGHTING - TAIL LIGHTS
PE09036BAYERISCHE MOTOREN WERKE08/07/200912/22/2009REAR LAMP ILLUMINATION
 Odi has received complaints from consumers stating that their tail light assembly is not properly illuminating.the tail light assembly consists of a turn signal lamp, a tail lamp and a brake lamp.the complainants have indicated that the issue is with an 8 pin connector and associated ground wiring.these components are allegedly overheating and melting due to excessive electrical current that runs through the system.bmw issued a technical service bulletin (tsb) sib-630306 on february 2007 to address the condition by adding supplementary ground wiring to the tail lamp assembly.odi is upgrading to an ea to further investigate the issue.
DP09002BAYERISCHE MOTOREN WERKE04/08/200908/06/2009REAR LAMP ILLUMINATION
 In march 2009, the office of defects investigation (odi) received a petition from mr. mark peters requesting an investigation of rear lamp failure in model year 2002-2005 bmw 3-series vehicles.an information request letter was sent to bmw in april 2009, and odi received bmw's response in june 2009.the tail lamp assembly contains lighting for the brake lamps, tail lamps, and turn signals.a technical service bulletin (tsb) was issued by bmw in january of 2007 instructing service technicians to examine an 8 pin electrical connector for heat-related damage and to incorporate additional ground wiring to the connector.complainants have alleged that significant thermal damage to the connector and associated ground wiring has occurred.this condition can result in intermittent or total loss of all lighting (brake, tail, and turn signal) for the effected rear lamp assembly.odi will open a preliminary evaluation to further examine this issue including further evaluating bmw complaints and related warranty data.
EA09019BAYERISCHE MOTOREN WERKE12/18/2009REAR LAMP ILLUMINATION
 The outboard rear light assembly consists of a turn signal lamp, a tail lamp and a brake lamp.failure of the light assembly ground circuit results in loss of all three lamps.bmw submitted complaint and warranty information showing a significant number of rear lamp assembly failures due to an open ground connection at the eight pin connector of the light assembly.this results in the loss of the rear turn signal.overheating of the ground circuit electrical pin, possibly due to increased resistance and or high current flow, is indicated in some failures.additionally bmw issued a technical service bulletin (tsb) sib-630306 in february 2007 to address the condition by adding supplementary ground wiring to the tail lamp assembly.the additional ground wire added by the procedure reduces the current flow at the eight pin connector.odi is opening this ea to further investigate the issue.
EXTERIOR LIGHTING - TURN SIGNAL
EA09019BAYERISCHE MOTOREN WERKE12/18/2009REAR LAMP ILLUMINATION
 The outboard rear light assembly consists of a turn signal lamp, a tail lamp and a brake lamp.failure of the light assembly ground circuit results in loss of all three lamps.bmw submitted complaint and warranty information showing a significant number of rear lamp assembly failures due to an open ground connection at the eight pin connector of the light assembly.this results in the loss of the rear turn signal.overheating of the ground circuit electrical pin, possibly due to increased resistance and or high current flow, is indicated in some failures.additionally bmw issued a technical service bulletin (tsb) sib-630306 in february 2007 to address the condition by adding supplementary ground wiring to the tail lamp assembly.the additional ground wire added by the procedure reduces the current flow at the eight pin connector.odi is opening this ea to further investigate the issue.
DP09002BAYERISCHE MOTOREN WERKE04/08/200908/06/2009REAR LAMP ILLUMINATION
 In march 2009, the office of defects investigation (odi) received a petition from mr. mark peters requesting an investigation of rear lamp failure in model year 2002-2005 bmw 3-series vehicles.an information request letter was sent to bmw in april 2009, and odi received bmw's response in june 2009.the tail lamp assembly contains lighting for the brake lamps, tail lamps, and turn signals.a technical service bulletin (tsb) was issued by bmw in january of 2007 instructing service technicians to examine an 8 pin electrical connector for heat-related damage and to incorporate additional ground wiring to the connector.complainants have alleged that significant thermal damage to the connector and associated ground wiring has occurred.this condition can result in intermittent or total loss of all lighting (brake, tail, and turn signal) for the effected rear lamp assembly.odi will open a preliminary evaluation to further examine this issue including further evaluating bmw complaints and related warranty data.
PE09036BAYERISCHE MOTOREN WERKE08/07/200912/22/2009REAR LAMP ILLUMINATION
 Odi has received complaints from consumers stating that their tail light assembly is not properly illuminating.the tail light assembly consists of a turn signal lamp, a tail lamp and a brake lamp.the complainants have indicated that the issue is with an 8 pin connector and associated ground wiring.these components are allegedly overheating and melting due to excessive electrical current that runs through the system.bmw issued a technical service bulletin (tsb) sib-630306 on february 2007 to address the condition by adding supplementary ground wiring to the tail lamp assembly.odi is upgrading to an ea to further investigate the issue.

Consumer Complaints


Fail datemilesoccurencesPurchase date
EXTERIOR LIGHTING
06/01/200986000
 Tl- the contact owns a 2002 bmw m3. the contact stated that while driving at various speeds, all of the exterior lamps would sporadically fail. the vehicle was taken to the dealer who was unable to diagnose the failure. the manufacturer was made aware of the failure who did not offer any assistance since the vehicle was not included in any recalls. the vehicle was not repaired. the failure mileage was 86,000 and the current mileage was 108,000. the vin was not available. kmj
06/01/200986000
 Tl - the contact owns a 2002 bmw m3. the contact stated that while driving at various speeds all of exterior lamp would sporadically stop working. the vehicle was taken to the dealer who was unable to diagnosed the failure. the manufacturer was made aware of the failure who did not offered any assistance since the vehicle was not included on any recalls. the vehicle was not repaired. the failure mileage was 86,000 and the current mileage was 108,000. pm