Bulletins
| Bulletin | Bulletin date | Replacement Bulletin | Item no. | Summary | Added |
|---|---|---|---|---|---|
| EXTERIOR LIGHTING | |||||
| SIB-63-02-01 | 08/01/2010 | 10037025 | Ready | 04/27/2011 | |
| SIB-63-02-01 | 08/01/2010 | 10037025 | Bmw: procedure for determining and replacing incandescent and halogen light bulbs under warranty. *rm | 04/27/2011 | |
Investigations
| NHTSA ID | Manufacturer | Date open | Date close | Subject | Recall campaign | |
|---|---|---|---|---|---|---|
| EXTERIOR LIGHTING | ||||||
| DP09002 | BAYERISCHE MOTOREN WERKE | 04/08/2009 | 08/06/2009 | REAR LAMP ILLUMINATION | ||
| In march 2009, the office of defects investigation (odi) received a petition from mr. mark peters requesting an investigation of rear lamp failure in model year 2002-2005 bmw 3-series vehicles.an information request letter was sent to bmw in april 2009, and odi received bmw's response in june 2009.the tail lamp assembly contains lighting for the brake lamps, tail lamps, and turn signals.a technical service bulletin (tsb) was issued by bmw in january of 2007 instructing service technicians to examine an 8 pin electrical connector for heat-related damage and to incorporate additional ground wiring to the connector.complainants have alleged that significant thermal damage to the connector and associated ground wiring has occurred.this condition can result in intermittent or total loss of all lighting (brake, tail, and turn signal) for the effected rear lamp assembly.odi will open a preliminary evaluation to further examine this issue including further evaluating bmw complaints and related warranty data. | ||||||
| PE09036 | BAYERISCHE MOTOREN WERKE | 08/07/2009 | 12/22/2009 | REAR LAMP ILLUMINATION | ||
| Odi has received complaints from consumers stating that their tail light assembly is not properly illuminating.the tail light assembly consists of a turn signal lamp, a tail lamp and a brake lamp.the complainants have indicated that the issue is with an 8 pin connector and associated ground wiring.these components are allegedly overheating and melting due to excessive electrical current that runs through the system.bmw issued a technical service bulletin (tsb) sib-630306 on february 2007 to address the condition by adding supplementary ground wiring to the tail lamp assembly.odi is upgrading to an ea to further investigate the issue. | ||||||
| EA09019 | BAYERISCHE MOTOREN WERKE | 12/18/2009 | REAR LAMP ILLUMINATION | |||
| The outboard rear light assembly consists of a turn signal lamp, a tail lamp and a brake lamp.failure of the light assembly ground circuit results in loss of all three lamps.bmw submitted complaint and warranty information showing a significant number of rear lamp assembly failures due to an open ground connection at the eight pin connector of the light assembly.this results in the loss of the rear turn signal.overheating of the ground circuit electrical pin, possibly due to increased resistance and or high current flow, is indicated in some failures.additionally bmw issued a technical service bulletin (tsb) sib-630306 in february 2007 to address the condition by adding supplementary ground wiring to the tail lamp assembly.the additional ground wire added by the procedure reduces the current flow at the eight pin connector.odi is opening this ea to further investigate the issue. | ||||||
| EXTERIOR LIGHTING - BACK UP LIGHTS | ||||||
| DP09002 | BAYERISCHE MOTOREN WERKE | 04/08/2009 | 08/06/2009 | REAR LAMP ILLUMINATION | ||
| In march 2009, the office of defects investigation (odi) received a petition from mr. mark peters requesting an investigation of rear lamp failure in model year 2002-2005 bmw 3-series vehicles.an information request letter was sent to bmw in april 2009, and odi received bmw's response in june 2009.the tail lamp assembly contains lighting for the brake lamps, tail lamps, and turn signals.a technical service bulletin (tsb) was issued by bmw in january of 2007 instructing service technicians to examine an 8 pin electrical connector for heat-related damage and to incorporate additional ground wiring to the connector.complainants have alleged that significant thermal damage to the connector and associated ground wiring has occurred.this condition can result in intermittent or total loss of all lighting (brake, tail, and turn signal) for the effected rear lamp assembly.odi will open a preliminary evaluation to further examine this issue including further evaluating bmw complaints and related warranty data. | ||||||
| EXTERIOR LIGHTING - BRAKE LIGHTS | ||||||
| PE09036 | BAYERISCHE MOTOREN WERKE | 08/07/2009 | 12/22/2009 | REAR LAMP ILLUMINATION | ||
| Odi has received complaints from consumers stating that their tail light assembly is not properly illuminating.the tail light assembly consists of a turn signal lamp, a tail lamp and a brake lamp.the complainants have indicated that the issue is with an 8 pin connector and associated ground wiring.these components are allegedly overheating and melting due to excessive electrical current that runs through the system.bmw issued a technical service bulletin (tsb) sib-630306 on february 2007 to address the condition by adding supplementary ground wiring to the tail lamp assembly.odi is upgrading to an ea to further investigate the issue. | ||||||
| EA09019 | BAYERISCHE MOTOREN WERKE | 12/18/2009 | REAR LAMP ILLUMINATION | |||
| The outboard rear light assembly consists of a turn signal lamp, a tail lamp and a brake lamp.failure of the light assembly ground circuit results in loss of all three lamps.bmw submitted complaint and warranty information showing a significant number of rear lamp assembly failures due to an open ground connection at the eight pin connector of the light assembly.this results in the loss of the rear turn signal.overheating of the ground circuit electrical pin, possibly due to increased resistance and or high current flow, is indicated in some failures.additionally bmw issued a technical service bulletin (tsb) sib-630306 in february 2007 to address the condition by adding supplementary ground wiring to the tail lamp assembly.the additional ground wire added by the procedure reduces the current flow at the eight pin connector.odi is opening this ea to further investigate the issue. | ||||||
| DP09002 | BAYERISCHE MOTOREN WERKE | 04/08/2009 | 08/06/2009 | REAR LAMP ILLUMINATION | ||
| In march 2009, the office of defects investigation (odi) received a petition from mr. mark peters requesting an investigation of rear lamp failure in model year 2002-2005 bmw 3-series vehicles.an information request letter was sent to bmw in april 2009, and odi received bmw's response in june 2009.the tail lamp assembly contains lighting for the brake lamps, tail lamps, and turn signals.a technical service bulletin (tsb) was issued by bmw in january of 2007 instructing service technicians to examine an 8 pin electrical connector for heat-related damage and to incorporate additional ground wiring to the connector.complainants have alleged that significant thermal damage to the connector and associated ground wiring has occurred.this condition can result in intermittent or total loss of all lighting (brake, tail, and turn signal) for the effected rear lamp assembly.odi will open a preliminary evaluation to further examine this issue including further evaluating bmw complaints and related warranty data. | ||||||
| EXTERIOR LIGHTING - TAIL LIGHTS | ||||||
| PE09036 | BAYERISCHE MOTOREN WERKE | 08/07/2009 | 12/22/2009 | REAR LAMP ILLUMINATION | ||
| Odi has received complaints from consumers stating that their tail light assembly is not properly illuminating.the tail light assembly consists of a turn signal lamp, a tail lamp and a brake lamp.the complainants have indicated that the issue is with an 8 pin connector and associated ground wiring.these components are allegedly overheating and melting due to excessive electrical current that runs through the system.bmw issued a technical service bulletin (tsb) sib-630306 on february 2007 to address the condition by adding supplementary ground wiring to the tail lamp assembly.odi is upgrading to an ea to further investigate the issue. | ||||||
| EA09019 | BAYERISCHE MOTOREN WERKE | 12/18/2009 | REAR LAMP ILLUMINATION | |||
| The outboard rear light assembly consists of a turn signal lamp, a tail lamp and a brake lamp.failure of the light assembly ground circuit results in loss of all three lamps.bmw submitted complaint and warranty information showing a significant number of rear lamp assembly failures due to an open ground connection at the eight pin connector of the light assembly.this results in the loss of the rear turn signal.overheating of the ground circuit electrical pin, possibly due to increased resistance and or high current flow, is indicated in some failures.additionally bmw issued a technical service bulletin (tsb) sib-630306 in february 2007 to address the condition by adding supplementary ground wiring to the tail lamp assembly.the additional ground wire added by the procedure reduces the current flow at the eight pin connector.odi is opening this ea to further investigate the issue. | ||||||
| DP09002 | BAYERISCHE MOTOREN WERKE | 04/08/2009 | 08/06/2009 | REAR LAMP ILLUMINATION | ||
| In march 2009, the office of defects investigation (odi) received a petition from mr. mark peters requesting an investigation of rear lamp failure in model year 2002-2005 bmw 3-series vehicles.an information request letter was sent to bmw in april 2009, and odi received bmw's response in june 2009.the tail lamp assembly contains lighting for the brake lamps, tail lamps, and turn signals.a technical service bulletin (tsb) was issued by bmw in january of 2007 instructing service technicians to examine an 8 pin electrical connector for heat-related damage and to incorporate additional ground wiring to the connector.complainants have alleged that significant thermal damage to the connector and associated ground wiring has occurred.this condition can result in intermittent or total loss of all lighting (brake, tail, and turn signal) for the effected rear lamp assembly.odi will open a preliminary evaluation to further examine this issue including further evaluating bmw complaints and related warranty data. | ||||||
| EXTERIOR LIGHTING - TURN SIGNAL | ||||||
| EA09019 | BAYERISCHE MOTOREN WERKE | 12/18/2009 | REAR LAMP ILLUMINATION | |||
| The outboard rear light assembly consists of a turn signal lamp, a tail lamp and a brake lamp.failure of the light assembly ground circuit results in loss of all three lamps.bmw submitted complaint and warranty information showing a significant number of rear lamp assembly failures due to an open ground connection at the eight pin connector of the light assembly.this results in the loss of the rear turn signal.overheating of the ground circuit electrical pin, possibly due to increased resistance and or high current flow, is indicated in some failures.additionally bmw issued a technical service bulletin (tsb) sib-630306 in february 2007 to address the condition by adding supplementary ground wiring to the tail lamp assembly.the additional ground wire added by the procedure reduces the current flow at the eight pin connector.odi is opening this ea to further investigate the issue. | ||||||
| DP09002 | BAYERISCHE MOTOREN WERKE | 04/08/2009 | 08/06/2009 | REAR LAMP ILLUMINATION | ||
| In march 2009, the office of defects investigation (odi) received a petition from mr. mark peters requesting an investigation of rear lamp failure in model year 2002-2005 bmw 3-series vehicles.an information request letter was sent to bmw in april 2009, and odi received bmw's response in june 2009.the tail lamp assembly contains lighting for the brake lamps, tail lamps, and turn signals.a technical service bulletin (tsb) was issued by bmw in january of 2007 instructing service technicians to examine an 8 pin electrical connector for heat-related damage and to incorporate additional ground wiring to the connector.complainants have alleged that significant thermal damage to the connector and associated ground wiring has occurred.this condition can result in intermittent or total loss of all lighting (brake, tail, and turn signal) for the effected rear lamp assembly.odi will open a preliminary evaluation to further examine this issue including further evaluating bmw complaints and related warranty data. | ||||||
| PE09036 | BAYERISCHE MOTOREN WERKE | 08/07/2009 | 12/22/2009 | REAR LAMP ILLUMINATION | ||
| Odi has received complaints from consumers stating that their tail light assembly is not properly illuminating.the tail light assembly consists of a turn signal lamp, a tail lamp and a brake lamp.the complainants have indicated that the issue is with an 8 pin connector and associated ground wiring.these components are allegedly overheating and melting due to excessive electrical current that runs through the system.bmw issued a technical service bulletin (tsb) sib-630306 on february 2007 to address the condition by adding supplementary ground wiring to the tail lamp assembly.odi is upgrading to an ea to further investigate the issue. | ||||||
Consumer Complaints
| Fail date | miles | occurences | Purchase date |
|---|---|---|---|
| EXTERIOR LIGHTING | |||
| 07/30/2012 | 99647 | 1 | |
| My car was in a collision where the driver of car 1 was making a turn into the main street , she turned too wide and could not complete the turn and decided to back up..she slammed into my car ,damage was left front bumper ,broken parking light, damage left front fender , xenon headlight module,(causes the left head light to turn of sometimes) and the air bag light came on , diagnosis found drivers seat belt tensioner fault ,since there was the impact on the drivers side. the driver of car 1 was cited for he incident and also for driving on a learners permit alone. state farm only covered the body repair and declined the repair of the air bag and the head light. i am concerned about the safety of any one inside this car if there was any reason for the deployment of the air bag and it did not deploy at the time. my car was in perfect condition before this accident. i would like to have my car repaired and feel safe driving. *tr | |||
| 07/30/2012 | 99647 | ||
| My car was in a collision where the driver of car 1 was making a turn into the main street , she turned too wide and could not complete the turn and decided to back up..she slammed into my car ,damage was left front bumper ,broken parking light, damage left front fender , xenon headlight module,(causes the left head light to turn of sometimes) and the air bag light came on , diagnosis found drivers seat belt tensioner fault ,since there was the impact on the drivers side. the driver of car 1 was cited for he incident and also for driving on a learners permit alone.state farm only covered the body repair and declined the repair of the air bag and the head light. i am concerned about the safety of any one inside this car if there was any reason for the deployment of the air bag and it did not deploy at the time.my car was in perfect condition before this accident. i would like to have my car repaired and feel safe driving. | |||