Bulletins


BulletinBulletin dateReplacement BulletinItem no.SummaryAdded
SEATS
230460012/29/2000618409On some vehicles the front seat cushion pan cracked or the mounting weld nuts broke loose. *jb04/12/2001
2300800B11/24/2000230800A615688Subject regarding child seat tether anchors. *tt01/28/2001
23080003/03/2000233599A610635Subject regarding child seat tether anchors. *tt05/09/2000
23359909/03/1999607963Information on child seat tether anchors. *tt10/21/1999

Consumer Complaints


Fail datemilesoccurencesPurchase date
SEATS
108/04/1997
 Consumer stated the front driver seat is broken.*jb
06/13/199704/01/1993
 Manufacturer contacted and they offered to split the cost of replacement. i have the info and will furnish if requested. primarily the two front seats operate but seem to be loose. i also have the parts that broke off.
07/15/19962
 Driver's seat frame broke, almost causing loss of control. *ak
SEATS - FRONT ASSEMBLY - POWER ADJUST
09/06/20001
 Consumer took vehicle to dealer on recall 883 for the power seat adjuster but the dealer was unable to get the seat forward to remove it. nlm
 Consumer received recall # aa3 from chrysler to repair power seat on driver side which could develop a movement or inboard pivot bracket could break. consumer claimed that passenger's side has more movement, and is 4 times more broken than driver's side. but, chrysler would not cover passenger because chrsyler claimed they were not directed to do so by nhtsa.*ak
 Driver's side seat plastic liner has cracked.owner notes that these are power seats.cause has not been determined. *ak
09/26/1997
 Consumer stevens chrysler plymouth in milford ct., said, the power seat machanism needs to be replaced. consumer was exiting the vehicle when the front driver's side seatback broke. *ak
SEATS - FRONT ASSEMBLY - RECLINER
12/10/2000112/01/1992
 The passenger bucket seat, inboard seat-track is broken. this causes the inboard side to be loose. the inboard seat assy can move several inches up/down. this problem seems similar to the one described in a chrysler customer satisfaction notification wherin the inboard pivot bracket was to be replaced on the drivers seat. in what may be a related problem the fore/aft power seat motor is either burned out or defective. in short, the passenger bucket seat track assy. is defective and unsafe. the dealer parts department states that the entire seat track assy. must be replaced at a cost of $450 or so in parts alone. in that the passenger seat is unstable and that the problem is a defect in materials or design, i believe that this problem should be grounds for a recall and no cost repair. in addition, both passenger and driver seat tracks have had 6 inch plastic guides break and come loose from the track assy. this causes the seats to be mildly unstable and loose.
10/27/2000
 While driving seatback on driver's side collapsed. dealership was called about problem. entire seat will have to be replaced. . please provide any further information.*ak
10/27/2000109/01/1999
 While driving seatback on driver's side collapsed. dealership was phoned about problem. entire seat will have to be replaced. *ak
08/12/2000
 Seatback on the driver side has cracked. the right side of the seat is not being supported. dealer refused to see consumer because there was109,000 miles on vehicle. manufacture said it was not their problem.*ak the seat was repaired at no charge. *yh
06/10/199701/11/1993
 When left front seat or right front bucket seat are move backward or forward the small plastic inserts about 6 to 8 inches long will fall out and the seat will woble when you drive, something must be wron with the switch that cause the back rest to recline toward the rear seat.
01/20/19961
 Seat back collapsed due to bolt failure.
07/04/19960
 During vehicle operation, at 35 mph. the driver's side seatback broke. *ak