Recalls


CampaignManufacturerManufacturing dateType# of units affectedDate Owner notified MfgRecall Initiated byManufacturers of recalled vehicles/productsReport Recieved DateRecord Creation DateRegulation Part NumberFMVSS Number
STEERING - WHEEL AND HANDLE BAR
01I012000DAIMLERCHRYSLER CORPORATION to 01/22/1999I980008/08/2001ODICHRYSLER GROUP LLC07/05/200101/07/2002
Defect SummaryThis is not a safety recall in accordance with the safety act. however, it is deemed a safety improvement campaign by the agency. vehicle description: 1998-1999 chrysler sebring jxi limited convertibles. the steering column intermediate shaft coupler pinch bolt retaining pin could snag and/or fray the edge of the driver's side floor mat.
Consequence SummaryThis could interfere with the steering control of the vehicle.
Corrective SummaryDealer will replace the steering column intermediate shaft coupler pinch bolt and retaining pin. in addition, the front floor mats will be replaced.
NotesDaimlerchrysler has decided to conduct a customer satisfaction campaign to replace the steering column intermediate shaft coupler pinch bolt,retaining pin, e-clip and the front floor mats.owners can contact daimlerchrysler at 1-800-853-1403, concerning this program.

Bulletins


BulletinBulletin dateReplacement BulletinItem no.SummaryAdded
STEERING - HYDRAULIC POWER ASSIST - POWER STEERING FLUID
19069810/02/1998602893A new power steering fluid. *yc01/20/1999
STEERING - HYDRAULIC POWER ASSIST - PUMP
19019901/22/1999190597604311Procedures on aligning the power steering belt. *tt04/22/1999

Consumer Complaints


Fail datemilesoccurencesPurchase date
STEERING
05/12/20031
 The consumers vehicle experienced the same symptoms as recall #01i012000 which is related to the steering. the dealer refused to repair the problem because the vehicles vin was not included in the recall. *nlm
STEERING - COLUMN LOCKING - ANTI-THEFT DEVICE
 The anti-theft alarm light keeps flashing when the doors are locked and will not stop. dealer has not seen vehicle. *ak
STEERING - HYDRAULIC POWER ASSIST SYSTEM
02/09/20011
 While traveling at 30 mph on icy road condition vehicle spun out of control and landed facing west, when a 18 wheeler hit consumer at about 65 mph, and none of airbags deployed.*ak the air bags failed on head collision prior to the accident, the engine had over heated and would not start. door won't open due to power locks failure. *yh
103/16/1999
 When driving power steering failed, causing poor steering control , and in some cases loss of steering control. consomer has contacted dealer. dealer replaced power steering. also, sway bar bolt was missing or came off. *ak there was recurrence of noise under vehicle and loose bolts in subframe. *yh
STEERING - RACK AND PINION
07/22/200435000104/01/1999
 While driving consumer experienced erratic steering control. dealership informed the consumer that problem was caused by a rack and pinion failure. *ak the problem existed since the vehicle was first purchase. *sc
12/01/200106/01/1999
 This may also be related to another campaign , which is tsb number 984r, if that has any meaning. this deals with the steering column pinch bolt replacement. *ak