Bulletins
| Bulletin | Bulletin date | Replacement Bulletin | Item no. | Summary | Added |
|---|---|---|---|---|---|
| SERVICE BRAKES, AIR - DISC - ROTOR | |||||
| 9845 | 03/02/1998 | 601264 | Availability of hub-mount brake rotor machining equipment. *yc | 07/15/1998 | |
| SERVICE BRAKES, HYDRAULIC - ANTILOCK | |||||
| 95212 | 10/01/1995 | 46478 | The use of petroleum-based grease as a lubricant in servicing disc brakes is no longer acceptable because it may be incompatible with the rubber material used in the disc brake system. if petroleum-based grease is used to lubricate any par | 04/25/1996 | |
| SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS | |||||
| 985A14 | 03/18/1998 | 601014 | A knocking noise proportional to wheel rotation may be heard from the front brakes during gentle braking. *tt | 12/07/2000 | |
| 7369 | 11/01/1999 | 610796 | Some vehicles may exhibit grinding noise, or greater than normal brake roughness, when applying the brakes immediately after installing motorcraft front brake pad part number br-18 (xu2z-2v001-ra). *t | 05/15/2000 | |
| 13421 | 10/01/1999 | 609692 | Some vehicles may exhibit grinding noises, or greater than normal brake roughness when applying the brakes immediately after installing motorcraft br-18 front brake pad. *tt | 04/06/2000 | |
| 99194 | 09/20/1999 | 6090082 | Information for servicing and diagnosing brake vibration, brake inspection, and brake friction material replacement. *tt | 03/06/2000 | |
| 985A11 | 03/18/1998 | 601009 | Service tip information regarding elimination of sanding rotors and drums. *yc | 06/17/1998 | |
| 96222 | 10/21/1996 | 50941 | Brakes - elimination of sanding rotors and drums - service tip. *tw | 06/17/1997 | |
| 94237 | 11/01/1994 | 37733 | Revised master cylinder and brake booster for non-abs vehicles. *tw | 01/06/1995 | |
| SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC | |||||
| 985A19 | 03/18/1998 | 601019 | The front brakes may have a persistent squeal during braking at speeds below 56 km/h (35 mph). *tt | 06/18/1998 | |
| 985A13 | 03/18/1998 | 601012 | The use of petroleum-based grease as a lubricant in servicing disc brakes is no longer acceptable. *yc | 06/17/1998 | |
| 9562 | 03/01/1995 | 39900 | Roughness concern during brake application. *tw | 11/01/1995 | |
| SFA/94L01 | 03/01/1995 | 3011600 | Unknown | 11/01/1995 | |
| SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - PADS | |||||
| BC1016797230 | 01/23/1997 | 51515 | Front brake squeal/noise during light brakie applications below 35 mph, replace the pads/shims kit. *jd | 06/27/1997 | |
| 9732 | 02/03/1997 | 51658 | Brakes- front brake squeal below 56 km/h (35 mph)- vehicle with 14 inch wheels. *jd | 06/27/1997 | |
| BC3550972301 | 01/23/1997 | 51506 | Front brake squeal/noise during light brake applications below 35 mph, replace the pads/shims kit. *jd | 06/27/1997 | |
| SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - ROTOR | |||||
| 9814 | 01/19/1998 | 605562 | Subject regarding the availability of hub-mount brake rotor machining equipment. *tt | 07/09/1999 | |
| 985A5 | 03/18/1998 | 601003 | Hub-mount brake rotor machining equipment from rotunda is now approved for warranty and service use. *yc | 06/17/1998 | |
| SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - MASTER CYLINDER | |||||
| 985A15 | 03/18/1998 | 601015 | A revised master cylinder and brake booster is available for service on non-abs vehicles to further improve brake pedal feel and travel. *yc | 06/18/1998 | |
| SERVICE BRAKES, HYDRAULIC - SWITCHES - BRAKE LIGHT | |||||
| 02176 | 09/02/2002 | 10008580 | Lamp-brake-invadvertent disabling of brake shift interlock. *mj | 08/05/2004 | |
Consumer Complaints
| Fail date | miles | occurences | Purchase date |
|---|---|---|---|
| SERVICE BRAKES, HYDRAULIC | |||
| 10/07/2004 | 1 | ||
| While applying the brakes pedal went to the floor. consumer was unable to maintain control of the vehicle,it and hit another vehicle from the driver's side. no injuries reported. consumer took vehicle to dealer for inspection, and mechanic could not duplicate the problem. *ak | |||
| 11/22/1995 | 0 | ||
| Brake rotors have been turned twice, and pads replaced twice. when attempting to stop, the pedal went down to the floor , and the emergency brake was used in order to stop.*ak | |||
| SERVICE BRAKES, HYDRAULIC - ANTILOCK | |||
| 05/13/1995 | 1 | ||
| Abs: while trying to slow down, applied brakes brake pedal went to floor with no braking effect; hit back bumper of another vehicle. tt | |||
| SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS | |||
| 06/30/2002 | 1 | 07/05/2000 | |
| While vehicle was parked and without warning ignition started to crank, causing ignition switch to melt.*ak dealer found faulty ignition switch caused malfunction to burn wire on starter solenoid off causing car to turnover by itself. brake calipers, alternator, two air conditioner power hoses, master cylinder, starter and tires (tire information unknown) had to be replaced. *tt | |||
| 09/01/1999 | |||
| While driving and applying the brakes , they failed and pedal went to the floor. please provide further information. *ak | |||
| 09/05/1998 | |||
| The consumer has been experiencing problems with rear coil springs. rear coil springs broke. also, while driving, the brake lights illuminate consistently. in addition, the consumer has to start applying brakes at a long distance from the destination desired to stop. *ak | |||
| 08/12/1995 | |||
| The manifold to the air conditioner blew off while driving. also power steering went out and, there were no brakes while driving at 65 mph. consumer was able to pull over safely. *ak | |||
| 07/01/1994 | |||
| This vehicle has totally inadequate brakes. this is the only non-abs car i have ever owned where the brakes cannot be locked upintentionally at any speed. i have taken the car to a dealer on two occasions and all they did was bleed and clean the brakes. i have had brake pads and shoes replaced, the entire hydraulic system bled, new master cylinder installed, pedal and booster clearances checked. nothing makes a difference. i have seen from your other defect reports that there is a 'revised power booster and master cylinder' available. however, when i contact the dealers parts and service departments they dont know anything about this. any help would be appreciated. thank you! | |||
| 03/04/1996 | |||
| The brake pedal goes to the floor and the brakes do not always work in stopping the car. the car is equipped with disc brakes. please describe. *ak | |||
| 02/12/1995 | |||
| The consumer had an accident feb. 12, 1995 and the air bags didn't deploy. the brakes had been fixed 6 times since she had the car. please describe. tt | |||
| 12/12/1994 | 8 | 10/14/1994 | |
| Brakes repaired (8) times w/brakes failing to stop vehicle. tt ford replaced vehicle under the reacquired vehicle program, at time of replacement vehicle had 19169 miles. *slc | |||
| Had to have front brakes replaced because of grinding, still not stopping properly. tt | |||
| 06/01/1995 | 3 | ||
| Brake pedal goes completely hard and vehicle can't be stopped. tt | |||
| 06/14/1995 | |||
| Brake system failure, loss of braking ability. tt | |||
| Experienced brake failure when pedal went to floor, and heard metal to metal sound upon braking, also brake light comes on intermittently while driving. tt | |||
| 08/15/1994 | 1 | ||
| Brake failure. *ak | |||
| SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - PADS | |||
| 11/22/1995 | 0 | ||
| Brake rotors have been turned twice, and pads replaced twice. when attempting to stop, the pedal went down to the floor , and the emergency brake was used in order to stop.*ak | |||
| 06/23/1995 | 3 | ||
| Brake pads wear prematurely. *skd | |||
| SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - ROTOR | |||
| 11/22/1995 | 0 | ||
| Brake rotors have been turned twice, and pads replaced twice. when attempting to stop, the pedal went down to the floor , and the emergency brake was used in order to stop.*ak | |||
| 12/24/1994 | |||
| The brake rotors have been replaced three times in a 6 month period. please explain. tt | |||
| SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - MASTER CYLINDER | |||
| 11/06/1998 | 2 | ||
| Brake pedal goes 1/4 to 1/2 way to the floor before brakes engage. very spongy feel. twice have almost rearended other cars at highway speeds during rush hour. have taken car to local goodyear service to inspect brakes and bleed air from the system. they say brake pads and shoes are fine and that they found no air bubbles or contaminated fluid when they tried bleeding the system. they said that ford has a tsb out for the escort for this problem and that the hydraulic master cylinder and booster both need to be replaced to solve this problem. this is totally unsafe and if ford is aware of this problem why hasn't there been a recall. ford should be replacing these parts at thier expence. my familys safety and others on the road with me are at risk. i have not contacted the dealer yet; this report is to document the problem and is my first step in trying to resolve this problem. women seem to be taken advantage of when dealing with service managers. i would appreciate any help you could be with resolving this problem. | |||
| 05/13/1995 | 1 | ||
| Master cylinder failure. *ak | |||
| SERVICE BRAKES, HYDRAULIC - PEDALS AND LINKAGES | |||
| 09/27/1995 | 7 | ||
| Brake pedal extends all the way to the floor, causing brake/accelerator pedal to be depressed simultaneously. *sd | |||
| SERVICE BRAKES, HYDRAULIC - POWER ASSIST | |||
| 03/01/1994 | 1 | 03/01/1994 | |
| Power brakes fail intermittently. | |||