Bulletins
| Bulletin | Bulletin date | Replacement Bulletin | Item no. | Summary | Added |
|---|---|---|---|---|---|
| STRUCTURE - BODY - HOOD | |||||
| H-38 | 11/01/2008 | 10028124 | Chrysler: two primary hood latches that may have been incorrectly manufactured and could fail primary hood latch failure on one side can cause hood to flutter on affected side. csc letter was received. *pe | 03/04/2009 | |
Consumer Complaints
| Fail date | miles | occurences | Purchase date |
|---|---|---|---|
| STRUCTURE | |||
| 01/01/2010 | 6500 | 1 | |
| After removing the rear-mounted spare tire on my 2009 jeep wrangler unlimited rubicon (4 door, 4wd) i noticed that the outer insulation (conduit) protecting the wiring harness for the third brake light had rubbed against the hard plastic grommet where the wiring harness exits the rear (outside) panel of the tailgate. the insulation had rubbed down to the point that the inner wires and their insulation were showing. this is a safety defect since, if not addressed, the rubbing would eventually go through the insulation on the wires, causing a short in close proximity to the spare tire. i reported my findings to jeep customer service and also took the vehicle to my local dealer. the dealer replaced the oem grommet with a rubber piece, and then ordered and installed a new wiring harness. *tr | |||
| STRUCTURE - BODY - HOOD - HINGE AND ATTACHMENTS | |||
| 12/21/2009 | 2000 | 1 | |
| The hood on my 2009 jeep wrangler will bounce 5 to 6 inches high in normal driving. if this breaks at highway speeds i fear losing control of the vehicle. *tr | |||