International Harvester 9300 1988

Model 9300 made in 1988 by International Harvester got 2 recalls. There was one recall concerning steering .

Model 1988

Recalls


CampaignManufacturerManufacturing dateType# of units affectedDate Owner notified MfgRecall Initiated byManufacturers of recalled vehicles/productsReport Recieved DateRecord Creation DateRegulation Part NumberFMVSS Number
STEERING - LINKAGES - TIE ROD ASSEMBLY
88V053000NAVISTAR INTL CORP.from 08/01/1987 to 02/01/1988V (Vehicle)321304/11/1988MFRINTERNATIONAL TRUCK & ENGINE CORPORATION04/05/198804/12/1988
Defect SummaryTie rod end tapered stud to the tie rod steering arms may not have been tightened to specified torque.
Consequence SummaryThe tie rod end nuts could loosen, shear off the lockingcotter pin and allow the tie rod to separate from the tie rod steering arm.this could cause vehicle to crash without prior warning.
Corrective SummaryInspect vehicles and tighten mounting tie rod end nuts to proper torque.
NotesSystem: steering/tie rod.vehicle description: heavy trucks.
STEERING - WHEEL AND HANDLE BAR
91V113000NAVISTAR INTL CORP.from 07/01/1986 to 06/01/1991V (Vehicle)1057307/09/1991MFRINTERNATIONAL TRUCK & ENGINE CORPORATION07/01/199107/16/1991
Defect SummaryThe two brackets used to mount the tilt/telescoping steering columns to the dash may experience failure due to fatigue stress; cracks in the radius area at the bottom of the left bracket could propagate upward until bracket failure occurs.
Consequence SummaryFailure of the steering brackets can lead to loss ofvehicle control and an accident without prior warning.
Corrective SummaryInstall new redesigned steering column mounting brackets.
NotesSystem: steering column.vehicle description: heavy trucks equipped w/tilt/telescoping steering column.