Mci D4500 2012

Model D4500 made in 2012 by Mci got 12 investigations as well as 2 recalls. The car had some investigations: power train and suspension. There were some recalls concerningelectrical system and electronic stability control.

Model 2012

Recalls


CampaignManufacturerManufacturing dateType# of units affectedDate Owner notified MfgRecall Initiated byManufacturers of recalled vehicles/productsReport Recieved DateRecord Creation DateRegulation Part NumberFMVSS Number
ELECTRICAL SYSTEM
12V086000MOTOR COACH INDUSTRIES, INC V (Vehicle)4604/11/2012MFRMOTOR COACH INDUSTRIES, INC03/05/201203/05/2012
Defect SummaryMotor coach industries, inc (mci) is recalling certain model year 2012 d4505, d4500, and d4000istv motor coaches, equipped with a sedan style entrance door and an actia multiplex system. thirty minutes after the park brake is set and the ignition is turned off, the entrance door will close without warning.
Consequence SummaryThe entrance door will close without warning, increasing the risk of personal injury to people entering or exiting the bus.
Corrective SummaryMci will notify owners, and remedy the affected coaches by reprogramming the multiplex system, free of charge. the recall began on april 11, 2012. owners may contact mci at 1-800-241-2947.
NotesMci recall campaign number 384.customers may contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty: 1-800-424-9153); or go to http://www.safercar.gov.
ELECTRONIC STABILITY CONTROL
11V524000MOTOR COACH INDUSTRIES, INC V (Vehicle)196201/04/2012MFRMOTOR COACH INDUSTRIES, INC10/26/201110/28/2011
Defect SummaryMotor coach industries (mci) is recalling certain model year 2003, and 2007-2012 e and j models along with model year 2007-2012 d4000, d4005, d4500, d4505, d4000istv motor coaches equipped with meritor wabco electronic stability control (esc) modules, manufactured from october 2002, through october 2011. under certain road and driving conditions, vehicle body roll and road inclination characteristics may adversely affect the slip angle calculation of the electronic stability control (esc) system. this might cause the esc to perceive an over steering situation and therefore apply the outer wheel brake on the front axle until the vehicle is perceived to be stable.
Consequence SummaryIf the driver is slow to react during this esc intervention, the vehicle may deviate from the intended line of travel, increasing the risk of a crash.
Corrective SummaryMci will notify owners and replace the control module free of charge. the manufacturer has not yet provided an owner notification schedule. owners may contact mci customer service at 1-800-241-2947.
NotesMci safety recall number is 371.owners may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to http://www.safercar.gov .

Investigations


NHTSA IDManufacturerDate openDate closeSubjectRecall campaign
POWER TRAIN - DRIVELINE
PE12007MOTOR COACH INDUSTRIES, INC03/21/201209/20/2012MCI Driveshaft Safety Loop Failures
 Odi has identified certain mci coaches with powertrain configurations that may allow a driveshaft separated at the rearward universal joint to escape the guardian structure of the steerable tag axle and damage steering and braking components.the damaged components may increase the risk of a loss of vehicle control. the subject coaches include 806 model year 1992 through 2012 mci d and e series motor coaches with steerable tag axles.this preliminary evaluation is being upgraded to an engineering analysis (ea12-007) to further study the alleged defect and to determine if a safety defect exists. the odi report cited above can be viewed at www-odi.nhtsa.dot.gov/complaints: odi number 10447575.
EA12007MOTOR COACH INDUSTRIES, INC09/13/2012MCI Driveshaft Safety Loop Failures
 Odi has identified certain mci coaches with powertrain configurations that may allow a driveshaft separated at the rearward universal joint to escape the guardian structure of the steerable tag axle and damage steering and braking components.the damaged components may increase the risk of a loss of vehicle control. the subject coaches include 806 model year 1992 through 2012 mci d and e series motor coaches with steerable tag axles.this engineering analysis is being opened to further study the alleged defect and to determine if a safety defect exists. the odi report cited above can be viewed at www-odi.nhtsa.dot.gov/complaints: odi number 10447575.
EA12007MOTOR COACH INDUSTRIES, INC09/13/2012MCI Driveshaft Safety Loop Failures
 Odi has identified certain mci coaches with powertrain configurations that may allow a driveshaft separated at the rearward universal joint to escape the guardian structure of the steerable tag axle and damage steering and braking components.the damaged components may increase the risk of a loss of vehicle control. the subject coaches include 806 model year 1992 through 2012 mci d and e series motor coaches with steerable tag axles.this engineering analysis is being opened to further study the alleged defect and its determine if a safety defect exists. the odi report cited above can be viewed at www-odi.nhtsa.dot.gov/complaints: odi number 10447575.
PE12007MOTOR COACH INDUSTRIES, INC03/21/2012MCI Driveshaft Safety Loop Failures
 Representatives from a large bus fleet operator have alleged that they have experienced several driveshaft failures on mci d series buses beginning in march 2010.the failed driveshafts were not contained by the safety loops for the driveshaft.they assert that in two instances the driveshaft failures resulted in loss of control of the bus and in multiple injuries and fatalities.the vehicles have a steerable tag axle that is used to increase the gvwr while reducing the turning radius and minimizing tire scrub that would normally occur with a tandem rear axle configuration.in these buses, the transmission couples to the driveshaft which then passes through a guardian structure integral with the tag axle and a forward safety loop before it couples to the drive axle.the driveshafts in these models with certain engine/transmission combinations may not be encapsulated by a safety loop (or guardian structure of the tag axle) at the transmission end.testing done by the fleet operator suggests that in the event of a driveshaft/transmission coupling failure the shorter driveshafts could escape the tag axle pass-through guardian structure and disable the steering lock of the tag axle and potentially damage other safety systems such as brake lines.additional vehicle dynamic testing suggests that an unlocked passive steerable tag axle could cause a loss of vehicle control given sufficient speed and other conditions.odi has reviewed the material supplied by the fleet operator and believes that additional information is required to determine if a safety related defect exists.odi is opening this investigation in order to gather information to assess whether the subject vehicles contain a safety related defect.
SUSPENSION - MULTIPLE AXLE
PE12007MOTOR COACH INDUSTRIES, INC03/21/201209/20/2012MCI Driveshaft Safety Loop Failures
 Odi has identified certain mci coaches with powertrain configurations that may allow a driveshaft separated at the rearward universal joint to escape the guardian structure of the steerable tag axle and damage steering and braking components.the damaged components may increase the risk of a loss of vehicle control. the subject coaches include 806 model year 1992 through 2012 mci d and e series motor coaches with steerable tag axles.this preliminary evaluation is being upgraded to an engineering analysis (ea12-007) to further study the alleged defect and to determine if a safety defect exists. the odi report cited above can be viewed at www-odi.nhtsa.dot.gov/complaints: odi number 10447575.
EA12007MOTOR COACH INDUSTRIES, INC09/13/2012MCI Driveshaft Safety Loop Failures
 Odi has identified certain mci coaches with powertrain configurations that may allow a driveshaft separated at the rearward universal joint to escape the guardian structure of the steerable tag axle and damage steering and braking components.the damaged components may increase the risk of a loss of vehicle control. the subject coaches include 806 model year 1992 through 2012 mci d and e series motor coaches with steerable tag axles.this engineering analysis is being opened to further study the alleged defect and to determine if a safety defect exists. the odi report cited above can be viewed at www-odi.nhtsa.dot.gov/complaints: odi number 10447575.
EA12007MOTOR COACH INDUSTRIES, INC09/13/2012MCI Driveshaft Safety Loop Failures
 Odi has identified certain mci coaches with powertrain configurations that may allow a driveshaft separated at the rearward universal joint to escape the guardian structure of the steerable tag axle and damage steering and braking components.the damaged components may increase the risk of a loss of vehicle control. the subject coaches include 806 model year 1992 through 2012 mci d and e series motor coaches with steerable tag axles.this engineering analysis is being opened to further study the alleged defect and its determine if a safety defect exists. the odi report cited above can be viewed at www-odi.nhtsa.dot.gov/complaints: odi number 10447575.
PE12007MOTOR COACH INDUSTRIES, INC03/21/2012MCI Driveshaft Safety Loop Failures
 Representatives from a large bus fleet operator have alleged that they have experienced several driveshaft failures on mci d series buses beginning in march 2010.the failed driveshafts were not contained by the safety loops for the driveshaft.they assert that in two instances the driveshaft failures resulted in loss of control of the bus and in multiple injuries and fatalities.the vehicles have a steerable tag axle that is used to increase the gvwr while reducing the turning radius and minimizing tire scrub that would normally occur with a tandem rear axle configuration.in these buses, the transmission couples to the driveshaft which then passes through a guardian structure integral with the tag axle and a forward safety loop before it couples to the drive axle.the driveshafts in these models with certain engine/transmission combinations may not be encapsulated by a safety loop (or guardian structure of the tag axle) at the transmission end.testing done by the fleet operator suggests that in the event of a driveshaft/transmission coupling failure the shorter driveshafts could escape the tag axle pass-through guardian structure and disable the steering lock of the tag axle and potentially damage other safety systems such as brake lines.additional vehicle dynamic testing suggests that an unlocked passive steerable tag axle could cause a loss of vehicle control given sufficient speed and other conditions.odi has reviewed the material supplied by the fleet operator and believes that additional information is required to determine if a safety related defect exists.odi is opening this investigation in order to gather information to assess whether the subject vehicles contain a safety related defect.
SUSPENSION - REAR - AXLE - NON-POWERED AXLE ASSEMBLY
PE12007MOTOR COACH INDUSTRIES, INC03/21/201209/20/2012MCI Driveshaft Safety Loop Failures
 Odi has identified certain mci coaches with powertrain configurations that may allow a driveshaft separated at the rearward universal joint to escape the guardian structure of the steerable tag axle and damage steering and braking components.the damaged components may increase the risk of a loss of vehicle control. the subject coaches include 806 model year 1992 through 2012 mci d and e series motor coaches with steerable tag axles.this preliminary evaluation is being upgraded to an engineering analysis (ea12-007) to further study the alleged defect and to determine if a safety defect exists. the odi report cited above can be viewed at www-odi.nhtsa.dot.gov/complaints: odi number 10447575.
EA12007MOTOR COACH INDUSTRIES, INC09/13/2012MCI Driveshaft Safety Loop Failures
 Odi has identified certain mci coaches with powertrain configurations that may allow a driveshaft separated at the rearward universal joint to escape the guardian structure of the steerable tag axle and damage steering and braking components.the damaged components may increase the risk of a loss of vehicle control. the subject coaches include 806 model year 1992 through 2012 mci d and e series motor coaches with steerable tag axles.this engineering analysis is being opened to further study the alleged defect and to determine if a safety defect exists. the odi report cited above can be viewed at www-odi.nhtsa.dot.gov/complaints: odi number 10447575.
EA12007MOTOR COACH INDUSTRIES, INC09/13/2012MCI Driveshaft Safety Loop Failures
 Odi has identified certain mci coaches with powertrain configurations that may allow a driveshaft separated at the rearward universal joint to escape the guardian structure of the steerable tag axle and damage steering and braking components.the damaged components may increase the risk of a loss of vehicle control. the subject coaches include 806 model year 1992 through 2012 mci d and e series motor coaches with steerable tag axles.this engineering analysis is being opened to further study the alleged defect and its determine if a safety defect exists. the odi report cited above can be viewed at www-odi.nhtsa.dot.gov/complaints: odi number 10447575.
PE12007MOTOR COACH INDUSTRIES, INC03/21/2012MCI Driveshaft Safety Loop Failures
 Representatives from a large bus fleet operator have alleged that they have experienced several driveshaft failures on mci d series buses beginning in march 2010.the failed driveshafts were not contained by the safety loops for the driveshaft.they assert that in two instances the driveshaft failures resulted in loss of control of the bus and in multiple injuries and fatalities.the vehicles have a steerable tag axle that is used to increase the gvwr while reducing the turning radius and minimizing tire scrub that would normally occur with a tandem rear axle configuration.in these buses, the transmission couples to the driveshaft which then passes through a guardian structure integral with the tag axle and a forward safety loop before it couples to the drive axle.the driveshafts in these models with certain engine/transmission combinations may not be encapsulated by a safety loop (or guardian structure of the tag axle) at the transmission end.testing done by the fleet operator suggests that in the event of a driveshaft/transmission coupling failure the shorter driveshafts could escape the tag axle pass-through guardian structure and disable the steering lock of the tag axle and potentially damage other safety systems such as brake lines.additional vehicle dynamic testing suggests that an unlocked passive steerable tag axle could cause a loss of vehicle control given sufficient speed and other conditions.odi has reviewed the material supplied by the fleet operator and believes that additional information is required to determine if a safety related defect exists.odi is opening this investigation in order to gather information to assess whether the subject vehicles contain a safety related defect.